I followed the directions on the wiki page, but for whatever reason I can't use my wireless adapter.
$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
$ ndiswrapper -l
bcmwl5 : driver installed
device (14E4:4328) present
dmesg | grep ndis
[ 230.193156] ndiswrapper version 1.52 loaded (smp=yes, preempt=no)
[ 230.207241] ndiswrapper (link_pe_images:576): fixing KI_USER_SHARED_DATA address in the driver
[ 230.208556] ndiswrapper: driver bcmwl5 (Broadcom,10/12/2006, 4.100.15.5) loaded
[ 230.213247] ndiswrapper (NdisWriteErrorLogEntry:191): log: C000138D, count: 1, return_address: ffffffff88c205de
[ 230.213251] ndiswrapper (NdisWriteErrorLogEntry:194): code: 0x10b
[ 230.213260] ndiswrapper (mp_init:216): couldn't initialize device: C0000001
[ 230.213264] ndiswrapper (pnp_start_device:439): Windows driver couldn't initialize the device (C0000001)
[ 230.213272] ndiswrapper (mp_halt:259): device ffff810069696700 is not initialized - not halting
[ 230.213273] ndiswrapper: device eth%d removed
[ 230.213493] ndiswrapper: probe of 0000:0b:00.0 failed with error -22
[ 230.216850] usbcore: registered new interface driver ndiswrapper
$ lshw -C Network
WARNING: you should run this program as super-user.
*-network UNCLAIMED
description: Network controller
product: BCM4328 802.11a/b/g/n
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:0b:00.0
version: 05
width: 64 bits
clock: 33MHz
capabilities: cap_list
configuration: latency=0
Bookmarks