Code:
======== Wireless-Info START ========
System-Info ~~~~~~~~~~~~~~~~~~~~~~~~
BroPC 3.11.0-23-generic i686, Zorin OS 8, saucy
CPU : AMD Athlon Dual-Core QL-62
Memory : 3776 MB
Uptime : 12:54:40 up 6 min, 2 users, load average: 0.46, 0.49, 0.26
lspci ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
00:0a.0 Ethernet controller [0200]: NVIDIA Corporation MCP77 Ethernet [10de:0760] (rev a2)
Subsystem: Hewlett-Packard Company Device [103c:360a]
Kernel driver in use: forcedeth
--
07:00.0 Ethernet controller [0200]: Qualcomm Atheros AR242x / AR542x Wireless Network Adapter (PCI-Express) [168c:001c] (rev 01)
Subsystem: Hewlett-Packard Company AR5BXB63 (Foxconn) 802.11bg Mini PCIe NIC [103c:137a]
Kernel driver in use: ath5k
lsusb ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 002: ID 0bda:0158 Realtek Semiconductor Corp. USB 2.0 multicard reader
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
PCMCIA Card Info ~~~~~~~~~~~~~~~~~~~
iwconfig ~~~~~~~~~~~~~~~~~~~~~~~~~~~
wlan0 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
rfkill ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Interface Soft blocked Hard blocked
0: phy0: Wireless LAN no no
lsmod ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
hp_wmi 13702 0
sparse_keymap 13708 1 hp_wmi
ath5k 135055 0
ath 19187 1 ath5k
mac80211 517482 1 ath5k
cfg80211 401762 3 ath,ath5k,mac80211
mxm_wmi 12893 1 nouveau
wmi 18590 3 hp_wmi,mxm_wmi,nouveau
module parameters ~~~~~~~~~~~~~~~~~~
ath5k (3): fastchanswitch=N | nohwcrypt=N | no_hw_rfkill_switch=N
cfg80211 (2): cfg80211_disable_40mhz_24ghz=N | ieee80211_regdom=00
mac80211 (5): beacon_loss_count=7 | ieee80211_default_rc_algo=minstrel_ht | max_nullfunc_tries=2 | max_probe_tries=5 | probe_wait_ms=500
wmi (2): debug_dump_wdg=N | debug_event=N
nm-tool ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
State: connected (global)
============================o=============o===========o==============o=========o===========o==============o===========
Interface & ID | Type | Driver | State | Default | Speed | Support | HW Addr
============================o=============o===========o==============o=========o===========o==============o===========
wlan0 | 802.11 WiFi | ath5k | disconnected | no | | WEP/WPA/WPA2 | <MAC wlan0>
----------------------------+-------------+-----------+--------------+---------+-----------+--------------+-----------
eth0 [Wired connection 1] | Wired | forcedeth | connected | yes | 100 Mb/s | | <MAC eth0>
Address: 192.168.1.11
Prefix: 24 (255.255.255.0)
Gateway: 192.168.1.1
DNS: 192.168.1.1
----------------------------+-------------+-----------+--------------+---------+-----------+--------------+-----------
NetworkManager.state ~~~~~~~~~~~~~~~
[main]
NetworkingEnabled=true
WirelessEnabled=true
WWANEnabled=true
WimaxEnabled=true
NetworkManager.conf ~~~~~~~~~~~~~~~~
[main]
plugins=ifupdown,keyfile,ofono
dns=dnsmasq
[ifupdown]
managed=false
NM WiFi Profiles ~~~~~~~~~~~~~~~~~~~
interfaces ~~~~~~~~~~~~~~~~~~~~~~~~~
# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback
resolv.conf ~~~~~~~~~~~~~~~~~~~~~~~~
nameserver 127.0.1.1
search Home
Routes & Ping ~~~~~~~~~~~~~~~~~~~~~~
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
192.168.1.0 0.0.0.0 255.255.255.0 U 1 0 0 eth0
--- 192.168.1.1 ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 999ms
rtt min/avg/max/mdev = 0.374/0.415/0.457/0.046 ms
--- 127.0.1.1 ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 999ms
rtt min/avg/max/mdev = 0.050/0.053/0.057/0.008 ms
iw reg get ~~~~~~~~~~~~~~~~~~~~~~~~~
(Region : "en_US.UTF-8")
country 00:
(2402 - 2472 @ 40), (3, 20)
(2457 - 2482 @ 40), (3, 20), PASSIVE-SCAN, NO-IBSS
(2474 - 2494 @ 20), (3, 20), NO-OFDM, PASSIVE-SCAN, NO-IBSS
(5170 - 5250 @ 40), (3, 20), PASSIVE-SCAN, NO-IBSS
(5735 - 5835 @ 40), (3, 20), PASSIVE-SCAN, NO-IBSS
iwlist chan ~~~~~~~~~~~~~~~~~~~~~~~~
wlan0 11 channels in total; available frequencies :
Channel 01 (2.412 GHz) - 11 (2.462 GHz)
iwlist scan ~~~~~~~~~~~~~~~~~~~~~~~~
wlan0 No scan results
blacklist ~~~~~~~~~~~~~~~~~~~~~~~~~~
[/etc/modprobe.d/blacklist-ath_pci.conf]
blacklist ath_pci
modinfo ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
[ath5k]
filename: /lib/modules/3.11.0-23-generic/kernel/drivers/net/wireless/ath/ath5k/ath5k.ko
srcversion: 68167C5D7C0F1F5FF5D8D62
depends: mac80211,cfg80211,ath
parm: nohwcrypt:Disable hardware encryption. (bool)
parm: fastchanswitch:Enable fast channel switching for AR2413/AR5413 radios. (bool)
parm: no_hw_rfkill_switch:Ignore the GPIO RFKill switch state (bool)
[ath]
filename: /lib/modules/3.11.0-23-generic/kernel/drivers/net/wireless/ath/ath.ko
srcversion: A890CDBC88E6EF28CD751DD
depends: cfg80211
[mac80211]
filename: /lib/modules/3.11.0-23-generic/kernel/net/mac80211/mac80211.ko
srcversion: 839D52631DD36C78B3B909C
depends: cfg80211
parm: max_nullfunc_tries:Maximum nullfunc tx tries before disconnecting (reason 4). (int)
parm: max_probe_tries:Maximum probe tries before disconnecting (reason 4). (int)
parm: beacon_loss_count:Number of beacon intervals before we decide beacon was lost. (int)
parm: probe_wait_ms:Maximum time(ms) to wait for probe response before disconnecting (reason 4). (int)
parm: ieee80211_default_rc_algo:Default rate control algorithm for mac80211 to use (charp)
[cfg80211]
filename: /lib/modules/3.11.0-23-generic/kernel/net/wireless/cfg80211.ko
srcversion: A9AE06A9BEF1DAB62A8C8ED
depends:
parm: ieee80211_regdom:IEEE 802.11 regulatory domain code (charp)
parm: cfg80211_disable_40mhz_24ghz:Disable 40MHz support in the 2.4GHz band (bool)
udev rules ~~~~~~~~~~~~~~~~~~~~~~~~~
# PCI device 0x10de:0x0760 (forcedeth)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="<MAC eth0>", ATTR{dev_id}=="0x0", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
# PCI device 0x168c:0x001c (ath5k)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="<MAC wlan0>", ATTR{dev_id}=="0x0", ATTR{type}=="1", KERNEL=="wlan*", NAME="wlan0"
Custom files/entries ~~~~~~~~~~~~~~~
/etc/modules : Default
/etc/rc.local : Default
/etc/modprobe.d : Not Default
/etc/pm/(cnf|pw|sl) : Default
[/etc/modprobe.d]
iwlwifi.conf : remove iwlwifi \
(/sbin/lsmod | grep -o -e ^iwlmvm -e ^iwldvm -e ^iwlwifi | xargs /sbin/rmmod) \
&& /sbin/modprobe -r mac80211
mlx4.conf : softdep mlx4_core post: mlx4_en
Kernel boot line ~~~~~~~~~~~~~~~~~~~
BOOT_IMAGE=/boot/vmlinuz-3.11.0-23-generic root=UUID=65a10b57-4cf7-4d97-8ac2-2bf523ed5fcd ro quiet splash vt.handoff=7
dmesg ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
[ 0.977548] audit: initializing netlink socket (disabled)
[ 1.644118] wmi: Mapper loaded
[ 1.663340] forcedeth: Reverse Engineered nForce ethernet driver. Version 0.64.
[ 27.280351] ath5k 0000:07:00.0: can't disable ASPM; OS doesn't have ASPM control
[ 27.280497] ath5k 0000:07:00.0: registered as 'phy0'
[ 27.297903] microcode: Microcode Update Driver: v2.00 <tigran@aivazian.fsnet.co.uk>, Peter Oruba
[ 27.973225] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 28.228783] ath: EEPROM regdomain: 0x64
[ 28.228791] ath: EEPROM indicates we should expect a direct regpair map
[ 28.228795] ath: Country alpha2 being used: 00
[ 28.228797] ath: Regpair used: 0x64
[ 28.258627] ath5k: phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70)
[ 29.827779] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 29.831178] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
======== Done ========
Adv Reply
Originally Posted by Soren_van_Zorin
Bookmarks