Results 1 to 10 of 10

Thread: Ubuntu 12.04 and 13.10: Radeon 4250 HDMI Black Screen on Boot

Threaded View

  1. #1
    Join Date
    May 2005
    Location
    Atlanta, GA
    Beans
    38
    Distro
    Ubuntu 12.04 Precise Pangolin

    Ubuntu 12.04 and 13.10: Radeon 4250 HDMI Black Screen on Boot

    So I've been scouring the archives and forums for anyone experiencing this issue, but haven't found anyone with the exact same problem, so here goes:

    - Ubuntu 12.04 HTPC is hooked up to Samsung SmartTV via HDMI
    - Upon boot, I see POST, I see the blinking cursor of grub doing it's thing, I see a purple screen (plymouth?), then all goes black and TV reports "No Signal"
    - PC is responsive, I can SSH, ping, etc, just no display
    Here's where it gets WEIRD:
    - Leaving the PC plugged into HDMI, I hooked up another monitor via DVI, and then HDMI suddenly works (but DVI monitor remains black). I can then unplug the monitor and carry on happily using the TV as my monitor, until the next boot.

    I've tried the following:
    - Turn TV off, boot, then turn TV On
    - Disable splash in grub [link]
    - Install Radeon Driver [Link]
    - Change resolution of Display in Ubuntu

    All to no avail. It would appear the the graphics card driver is working fine as after I plug in the DVI monitor and remove it, everything works and looks great. I've even had the TV display go to sleep after not interacting with the PC, the TV reports no signal (as it should), then when I move the mouse, the display comes back. Audio works over HDMI with no issues, but only after I perform my DVI plug/unplug trick.

    I'm at my wit's end, I can't figure this out. Note that this issue just started occurring after performing a HD swap and reinstall with 13.10- I did not have this issue at all running Ubuntu 12.04 until after my reinstall. I still have the HD and original install on the old HD, it's just sitting in a different workstation. I've confirmed that Grub settings are the same on this new install than with the old install. I've since "fallen back" to Ubuntu 12.04, but this issue is still occurring.

    If absolutely need be, I can pull the original drive from my other PC and boot from that to check other settings, but I'd prefer to not have to do so. I have the drive mounted, so I can pull conf settings from it if needed.

    GPU is built into the motherboard - Radeon 4250
    TV is Samsung SmartTV 50"
    When I got to "Display" in Ubuntu, it correctly recognizes the TV as a display

    dmesg | grep 'drm|radeon' results in the following:

    [ 0.000000] Command line: BOOT_IMAGE=/boot/vmlinuz-3.8.0-29-generic root=UUID=0c6dae95-8e8a-40ab-8be0-5452f53b93da ro radeon.audio=1
    [ 0.000000] Kernel command line: BOOT_IMAGE=/boot/vmlinuz-3.8.0-29-generic root=UUID=0c6dae95-8e8a-40ab-8be0-5452f53b93da ro radeon.audio=1
    [ 6.476770] [drm] Initialized drm 1.1.0 20060810
    [ 6.694062] [drm] radeon defaulting to kernel modesetting.
    [ 6.694066] [drm] radeon kernel modesetting enabled.
    [ 6.711171] [drm] initializing kernel modesetting (RS880 0x1002:0x9715 0x1849:0x9715).
    [ 6.711196] [drm] register mmio base: 0xFE9F0000
    [ 6.711197] [drm] register mmio size: 65536
    [ 6.711769] radeon 0000:01:05.0: VRAM: 256M 0x00000000C0000000 - 0x00000000CFFFFFFF (256M used)
    [ 6.711771] radeon 0000:01:05.0: GTT: 512M 0x00000000A0000000 - 0x00000000BFFFFFFF
    [ 6.712047] [drm] Detected VRAM RAM=256M, BAR=256M
    [ 6.712050] [drm] RAM width 32bits DDR
    [ 6.712276] [drm] radeon: 256M of VRAM memory ready
    [ 6.712277] [drm] radeon: 512M of GTT memory ready.
    [ 6.712294] [drm] GART: num cpu pages 131072, num gpu pages 131072
    [ 6.713119] [drm] Loading RS780 Microcode
    [ 7.068766] [drm] PCIE GART of 512M enabled (table at 0x00000000C0040000).
    [ 7.068853] radeon 0000:01:05.0: WB enabled
    [ 7.068856] radeon 0000:01:05.0: fence driver on ring 0 use gpu addr 0x00000000a0000c00 and cpu addr 0xffff880115b30c00
    [ 7.068858] radeon 0000:01:05.0: fence driver on ring 3 use gpu addr 0x00000000a0000c0c and cpu addr 0xffff880115b30c0c
    [ 7.068860] [drm] Supports vblank timestamp caching Rev 1 (10.10.2010).
    [ 7.068861] [drm] Driver supports precise vblank timestamp query.
    [ 7.068874] [drm] radeon: irq initialized.
    [ 7.069101] radeon 0000:01:05.0: setting latency timer to 64
    [ 7.100669] [drm] ring test on 0 succeeded in 1 usecs
    [ 7.100725] [drm] ring test on 3 succeeded in 1 usecs
    [ 7.100785] [drm] Enabling audio support
    [ 7.100803] [drm] ib test on ring 0 succeeded in 0 usecs
    [ 7.100816] [drm] ib test on ring 3 succeeded in 0 usecs
    [ 7.100973] [drm] Radeon Display Connectors
    [ 7.100974] [drm] Connector 0:
    [ 7.100975] [drm] VGA-1
    [ 7.100977] [drm] DDC: 0x7e40 0x7e40 0x7e44 0x7e44 0x7e48 0x7e48 0x7e4c 0x7e4c
    [ 7.100977] [drm] Encoders:
    [ 7.100978] [drm] CRT1: INTERNAL_KLDSCP_DAC1
    [ 7.100979] [drm] Connector 1:
    [ 7.100980] [drm] HDMI-A-1
    [ 7.100981] [drm] HPD3
    [ 7.100982] [drm] DDC: 0x7e50 0x7e50 0x7e54 0x7e54 0x7e58 0x7e58 0x7e5c 0x7e5c
    [ 7.100982] [drm] Encoders:
    [ 7.100983] [drm] DFP3: INTERNAL_KLDSCP_LVTMA
    [ 7.100999] [drm] radeon: power management initialized
    [ 7.117168] radeon 0000:01:05.0: No connectors reported connected with modes
    [ 7.117174] [drm] Cannot find any crtc or sizes - going 1024x768
    [ 7.123724] [drm] fb mappable at 0xD0142000
    [ 7.123725] [drm] vram apper at 0xD0000000
    [ 7.123726] [drm] size 3145728
    [ 7.123727] [drm] fb depth is 24
    [ 7.123728] [drm] pitch is 4096
    [ 7.123822] fbcon: radeondrmfb (fb0) is primary device
    [ 7.130367] radeon 0000:01:05.0: fb0: radeondrmfb frame buffer device
    [ 7.130369] radeon 0000:01:05.0: registered panic notifier
    [ 7.130430] [drm] Initialized radeon 2.29.0 20080528 for 0000:01:05.0 on minor 0


    Please help!
    Last edited by mjsoccer1; October 25th, 2013 at 02:46 AM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •