Tons of error reports, hang-ups, failing repositories all since I last updated...

[CamPsych]

Hey all.

I have been having the same issue here, thanks to matt_symes on the Bugs thread and here for directing me. I have done the update and will see how I go, hopefully it fixes the problem. You guys are awesome.

[CamPsych]

Strange, I seem to be having wifi issues too now, have to write this from phone :/

[matt_symes]

Hi

@camPsych.

Are you still getting GPU hangs ?

Can you post the output of

sudo lshw -c network

and

lspci -nnk | grep -iA3 wireless

(capital A above) so we can check your network card.

Kind regards

[vadertater]

Error time!

I get a little info tab that states: It appears you are currently running a mainline kernel. It would be better to report this but upstream at http://bugzilla.kernel.org/ so that the upstreamkernel developers are aware of the issue. If you'd still like to file a bug against the ubuntu kernel, please boot with an official Ubuntu kernel and re-file

Ubuntu Error is the following:
Executable Path: /usr/share/apport/apportcheckresume
Page: linux-image-3.8.1-030801-generic .....
Problem Type: KernelOops
Title: Suspend/resumefailure
Annotation: This occured during a previous suspend and prevented it from resuming properly (the error did occur on start up, so this makes sense)
ApportVersion: 2.6.1-0ubuntu10
Architecture: amd64

And the list continues... do you need ProcMaps, Proc Status or Sleep Log??? These are much larger blocks of info that cannot be copied and pasted...

[matt_symes]

Hi

Wait 10 minutes. I'm just going to read that guide you followed to update the kernel.

It seems you are not using a Ubuntu kernel.

EDIT:

I don't seem to able able to click on that link so i don't know where you got the kernel from.

Use one of the kernels from here

http://kernel.ubuntu.com/~kernel-ppa/mainline/

At least we know that updating the kernel seems to fix the GPU hang issues.

How is your wireless behaving ? Any other issues besides the resume issue ?

Kind regards

[CamPsych]

Hey guys,

Having issues with connectivity.. results below...

#cameron@cameron-Aspire-E1-531:~$ sudo lshw -c network
*-network
description: Ethernet interface
product: NetLink BCM57785 Gigabit Ethernet PCIe
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:02:00.0
logical name: eth0
version: 10
serial: b8:88:e3:c0:5f:f2
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi msix pciexpress bus_master cap_list rom ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.128 firmware=sb latency=0 link=no multicast=yes port=twisted pair
resources: irq:16 memory:c0430000-c043ffff memory:c0440000-c044ffff memory:c0450000-c04507ff
*-network
description: Network controller
product: BCM4313 802.11b/g/n Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:03:00.0
version: 01
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: driver=bcma-pci-bridge latency=0
resources: irq:17 memory:c0500000-c0503fff
*-network
description: Wireless interface
physical id: 1
logical name: wlan0
serial: 08:3e:8e:4d:50:b5
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=brcmsmac driverversion=3.8.1-030801-generic firmware=N/A ip=192.168.0.5 link=yes multicast=yes wireless=IEEE 802.11bgn #

#cameron@cameron-Aspire-E1-531:~$ lspci -nnk | grep -iA3 wireless
03:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller [14e4:4727] (rev 01)
Subsystem: Foxconn International, Inc. Device [105b:e042]
Kernel driver in use: bcma-pci-bridge
Kernel modules: bcma #

Other issue is that I am getting a black screen on waking from sleep, HDD seems to make a noise as though to to start, but nothing, even if I wait. Have to do a hard reboot every time that it does this. No error messages are associated with this.

[wildmanne39]

I have the same problem with a new laptop, where is the best place to get the upgraded kernel from? for 12.04 with directions for installing.
Thanks

[CamPsych]

Just to clarify...caught the screen in a different light and seems that the screen is completely darkened, can just see the desktop. Efforts to lighten screen fail.

Just as a sidebar, how do I correctly post code?

[wildmanne39]

Nevermind found and installed the new kernel.
Thanks

[schragge]

Just as a sidebar, how do I correctly post code?

When you click on Adv Reply, you will see the # button on the toolbar above the text input area. It inserts [code][/code] tags around the selected text. You can wrap text in these tags by hand, too.