Hello all,
I just purchased the Netgear WNDA3100 adaptor and used ndiswrapper to pull in the bcmwlhigh5.inf windows driver. It looks like I'm almost there, but I can't tell why it's not working.
andCode:$ lsusb Bus 001 Device 003: ID 0846:9011 NetGear, Inc. WNDA3100v2 802.11abgn [Broadcom BCM4323]
look good. But ifCode:$ ndiswrapper -l bcmn43xx64 : driver installed device (0846:9011) present
shows my old wireless (wlan0). I've been having issues with the onboard wireless card which is why I bought the new one. Any thoughts on why I'm not seeing a wlan1?Code:$ iwconfig lo no wireless extensions. wlan0 IEEE 802.11bgn ESSID:"Wireless-N(2.4G)" Mode:Managed Frequency:2.462 GHz Access Point: 00:E0:4C:81:96:D1 Bit Rate=9 Mb/s Tx-Power=20 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:on Link Quality=41/70 Signal level=-69 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:301 Invalid misc:182 Missed beacon:0 eth0 no wireless extensions.
Thanks so much for the help!
Bookmarks