I've got the same problem, have a no-name wireless card, which shows up as a Ralink RT2800. The card is detected and can see my wireless network, but it won't connect.
lspci shows:
Code:
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)
04:00.0 Network controller: Ralink corp. Device 3062
lsmod
Code:
rt2800pci 18340 0
rt2800lib 48909 1 rt2800pci
crc_ccitt 12595 1 rt2800lib
rt2x00pci 14202 1 rt2800pci
rt2x00lib 48146 3 rt2800pci,rt2800lib,rt2x00pci
mac80211 393421 3 rt2800lib,rt2x00pci,rt2x00lib
cfg80211 172427 2 rt2x00lib,mac80211
emu10k1_gp 12570 0
gameport 15060 2 emu10k1_gp
eeprom_93cx6 12653 1 rt2800pci
psmouse 73673 0
soundcore 12600 1 snd
snd_page_alloc 14115 3 snd_hda_intel,snd_emu10k1,snd_pcm
serio_raw 12990 0
lp 17455 0
parport 40930 3 ppdev,parport_pc,lp
r8169 43104 0
firewire_ohci 35854 0
firewire_core 56937 1 firewire_ohci
crc_itu_t 12627 1 firewire_core
lspci -nnk | grep -iA2 net shows:
Code:
03:00.0 Ethernet controller [0200]: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller [10ec:8168] (rev 01)
Subsystem: Giga-byte Technology GA-EP45-DS5 Motherboard [1458:e000]
Kernel driver in use: r8169
--
04:00.0 Network controller [0280]: Ralink corp. Device [1814:3062]
Subsystem: Ralink corp. Device [1814:3062]
Kernel driver in use: rt2800pci
lshw -C network shows:
Code:
*-network
description: Ethernet interface
product: RTL8111/8168B PCI Express Gigabit Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:03:00.0
logical name: eth0
version: 01
serial: 00:1f:d0:87:2b:1e
size: 100Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm vpd msi pciexpress bus_master cap_list rom ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full firmware=N/A ip=192.168.1.12 latency=0 link=yes multicast=yes port=MII speed=100Mbit/s
resources: irq:43 ioport:c000(size=256) memory:f7000000-f7000fff memory:7ff00000-7ff1ffff
*-network
description: Wireless interface
product: Ralink corp.
vendor: Ralink corp.
physical id: 0
bus info: pci@0000:04:00.0
logical name: wlan0
version: 00
serial: c8:3a:35:cd:da:78
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=rt2800pci driverversion=3.0.0-16-generic firmware=0.34 latency=32 link=no maxlatency=4 mingnt=2 multicast=yes wireless=IEEE 802.11bgn
resources: irq:20 memory:f8000000-f800ffff
iwconfig:
Code:
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
Any help getting the wireless connected would be great!
Bookmarks