I'm unable to get my Samsung printer ML-2010 to working with my new distro, Lucid 10.04 LTS.

With the printer plugged in by usb, and turned on of course:

I tried (System--Admin--Printing) localhost, but was unable get it working there, perhaps because I don't know the printer's URI.


I also read up on this, and tried the terminal: dmesg | tail -n40
The output is below. Any help is greatly appreciated!


craig@craig-desktop:~$ dmesg | tail -n40
[ 15.880577] domain 0: span 0-1 level MC
[ 15.880580] groups: 0 1
[ 15.880587] CPU1 attaching sched-domain:
[ 15.880589] domain 0: span 0-1 level MC
[ 15.880591] groups: 1 0
[ 20.732516] eth0: no IPv6 routers present
[ 72.160027] Clocksource tsc unstable (delta = -291635844 ns)
[ 3210.336045] DMA write timed out
[ 3280.368041] parport0: FIFO is stuck
[ 3280.408037] parport0: BUSY timeout (1) in compat_write_block_pio
p0 releasing parport
[ 8140.948057] usb 2-8: new full speed USB device using ohci_hcd and address 3
[ 8141.164135] usb 2-8: configuration #1 chosen from 1 choice
[ 8141.765161] usblp0: USB Bidirectional printer dev 3 if 0 alt 0 proto 2 vid 0x04E8 pid 0x326C
[ 8141.765209] usbcore: registered new interface driver usblp
[ 8142.542015] usb 2-8: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[ 8144.511951] __ratelimit: 18 callbacks suppressed
[ 8144.511963] udev-configure-[2957]: segfault at 0 ip 0023c637 sp bfc489c8 error 4 in libc-2.11.1.so[1c2000+153000]