Results 1 to 3 of 3

Thread: spacecam 120 problems

  1. #1
    Join Date
    Dec 2009

    Unhappy spacecam 120 problems

    i have a spacecam 120 and tried to install it under the sn9c102 chipset, first installing the driver, followed by a supported program sonic-snap.

    after the cam not being detected i was advised to go into terminal and see if the device was successfuly installed, this is what i found, and have had no luck so far in gettting any response from the cam.

    dmesg | less

    [15690.933049] usb 2-2: new full speed USB device using ohci_hcd and address 3
    [15691.143226] usb 2-2: configuration #1 chosen from 1 choice
    [15691.374761] Linux video capture interface: v2.00
    [15691.389715] sn9c102: V4L2 driver for SN9C1xx PC Camera Controllers v1:1.47pre49
    [15691.391154] usb 2-2: SN9C10[12] PC Camera Controller detected (vidid 0x0C45:0x600D)
    [15691.589056] usb 2-2: PAS106B image sensor detected
    [15692.259265] usb 2-2: Initialization succeeded
    [15692.259400] usb 2-2: V4L2 device registered as /dev/video0
    [15692.259406] usb 2-2: Optional device control through 'sysfs' interface disabled
    [15692.259447] usbcore: registered new interface driver sn9c102
    [15692.285224] usb 2-2: usb_submit_urb() failed, error -28
    [15692.358067] ohci_hcd 0000:00:0b.0: leak ed f642c100 (#81) state 2

    if anyone can help please do!

  2. #2
    Join Date
    Feb 2008
    Xubuntu 16.04 Xenial Xerus

    Re: spacecam 120 problems

    Here is a really old thread which might be relevant:

    Do you use Cheese to test the webcam? I've found it's the simplest program for the job.

  3. #3
    Join Date
    Dec 2009

    Re: spacecam 120 problems

    yeah i have cheese both installed, but when i try the cam on it i get some bars of colour and a little box with "tv like" white noise in the bottom corner, saying no webcam detected, i'll check out the link and let you know how i get on

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts