Yes !, it worked.. ! this time is, I extracted the ucode file directly to the firmware directory and its not showing that in dmesg anymore ! can't understand why that would happen, though.
now, lshw shows this :

Code:
tkudari@tkudari-laptop:~/Desktop$ sudo lshw -C network
  *-network               
       description: Wireless interface
       product: PRO/Wireless 4965 AG or AGN Network Connection
       vendor: Intel Corporation
       physical id: 0
       bus info: pci@0000:02:00.0
       logical name: wmaster0
       version: 61
       serial: 00:21:5c:74:7b:4b
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list logical ethernet physical wireless
       configuration: broadcast=yes driver=iwlagn latency=0 module=iwlagn multicast=yes wireless=IEEE 802.11abgn
  *-network
       description: Ethernet interface
       product: RTL8101E PCI Express Fast Ethernet controller
       vendor: Realtek Semiconductor Co., Ltd.
       physical id: 0
       bus info: pci@0000:08:00.0
       logical name: eth0
       version: 01
       serial: 00:1e:68:bf:7f:8f
       size: 100MB/s
       capacity: 100MB/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full ip=192.168.1.4 latency=0 link=yes module=r8169 multicast=yes port=MII speed=100MB/s
however, dmesg shows:
Code:
 ADDRCONF(NETDEV_UP): wlan0: link is not ready
also, the wireless LED is not turning on..