Iomega ZIP 250 not mounting

[stepstools]

Yah, I still use my 250 megabyte drive. But in 9.10 it stopped wanting to mount. I need an answer sort of fast. Any ideas?

[anglican]

Yah, I still use my 250 megabyte drive. But in 9.10 it stopped wanting to mount. I need an answer sort of fast. Any ideas?

When you put a disk in what (if anything) shows up in the last few lines of "dmesg"?

H

[stepstools]

Nothing happens when I put a disk in, what's "dmesg"?

[stepstools]

Got Something -

[ 2418.848498] sd 6:0:0:0: [sdb] CDB: Read(10): 28 00 00 07 77 80 00 00 08 00
[ 2418.848527] end_request: I/O error, dev sdb, sector 489344
[ 2418.848540] Buffer I/O error on device sdb, logical block 122336
[ 2418.848549] Buffer I/O error on device sdb, logical block 122337
[ 2644.420063] usb 3-1: new full speed USB device using uhci_hcd and address 5
[ 2644.588540] usb 3-1: configuration #1 chosen from 1 choice
[ 2644.607638] scsi7 : SCSI emulation for USB Mass Storage devices
[ 2644.612713] usb-storage: device found at 5
[ 2644.612717] usb-storage: waiting for device to settle before scanning
[ 2649.613389] usb-storage: device scan complete
[ 2649.617382] scsi 7:0:0:0: Direct-Access     IOMEGA   ZIP 250          90.V PQ: 0 ANSI: 0 CCS
[ 2649.623191] sd 7:0:0:0: Attached scsi generic sg2 type 0

[anglican]

Got Something -

[ 2649.617382] scsi 7:0:0:0: Direct-Access     IOMEGA   ZIP 250          90.V PQ: 0 ANSI: 0 CCS
[ 2649.623191] sd 7:0:0:0: Attached scsi generic sg2 type 0

OK, it looks like the disk is seen but just not mounted. Try to create a mount point:

sudo mkdir /mnt/zip

Then mount it:

sudo mount /dev/sg2 /mnt/zip -o ro

If you get no error, look at the contents with:

ls -l /mnt/zip

Good luck.

H

[stepstools]

Second command returned this -

mount: special device /dev/sg2 does not exist