problem in webcam driver installation

[shariefbe]

i installed the new kernel version 2.6.26......in that i selected the module zc0301 as module ie as <m>....but when i inserted the camera the module is installed automatically.....and when i press "dmesg" its showing that the driver is installed.....and when i type "lsmod" the driver zc0301 is there...i dont what happened..but i selected that module as loadable module.....the main thing is my camera is not working..but its in active now..

output of dmesg is:

[ 118.644060] usb 2-1: new full speed USB device using uhci_hcd and address 2
[ 118.828152] usb 2-1: configuration #1 chosen from 1 choice
[ 119.046540] Linux video capture interface: v2.00
[ 119.101722] zc0301: V4L2 driver for ZC0301[P] Image Processor and Control Chip v1:1.10
[ 119.102437] usb 2-1: ZC0301[P] Image Processor and Control Chip detected (vid/pid 0x041E:0x4034)
[ 119.174269] usb 2-1: No supported image sensor detected
[ 119.174867] usbcore: registered new interface driver zc0301

output of lsmod is :

sharief@sharief-desktop:~$ lsmod
Module Size Used by
zc0301 47492 0
videodev 31232 1 zc0301
v4l1_compat 15364 1 videodev
ipv6 246500 14
af_packet 17152 2
rfcomm 33808 2
l2cap 20352 11 rfcomm
bluetooth 52836 4 rfcomm,l2cap
ppdev 8196 0
speedstep_lib 5380 0
cpufreq_conservative 7432 0
cpufreq_stats 5952 0
.
.
.
.
.
.
.
.
.
.


what to do...how to select that module as loadable module..