almos.dinnyes
October 31st, 2008, 02:41 PM
Last night I upgraded from 8.04 to 8.10, and compiz doesn't work well any more :(
If I start compiz all window frames (window decoration) disappear.
I tried to reinstall compiz, to reload it, to switch off the window decoration effect, but no success. Only metacity works.
I have an Acer Travelmate 6292 with Intel 965 chipset:
lspci -v
00:00.0 Host bridge: Intel Corporation Mobile PM965/GM965/GL960 Memory Controller Hub (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0
Capabilities: [e0] Vendor Specific Information <?>
Kernel driver in use: agpgart-intel
Kernel modules: intel-agp
00:02.0 VGA compatible controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0, IRQ 6
Memory at f0000000 (64-bit, non-prefetchable) [size=1M]
Memory at d0000000 (64-bit, prefetchable) [size=256M]
I/O ports at 1800 [size=8]
Capabilities: [90] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable-
Capabilities: [d0] Power Management version 3
Kernel modules: intelfb
00:02.1 Display controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0
Memory at f0100000 (64-bit, non-prefetchable) [size=1M]
Capabilities: [d0] Power Management version 3
and here is my xorg.conf
Section "Device"
Identifier "Configured Video Device"
EndSection
Section "Monitor"
Identifier "Configured Monitor"
EndSection
Section "Screen"
Identifier "Default Screen"
Monitor "Configured Monitor"
Device "Configured Video Device"
EndSection
Section "ServerLayout"
Identifier "Default Layout"
Screen "Default Screen"
# commented out by update-manager, HAL is now used
# InputDevice "Synaptics Touchpad"
EndSection
What shall I do to make compiz working again?
If I start compiz all window frames (window decoration) disappear.
I tried to reinstall compiz, to reload it, to switch off the window decoration effect, but no success. Only metacity works.
I have an Acer Travelmate 6292 with Intel 965 chipset:
lspci -v
00:00.0 Host bridge: Intel Corporation Mobile PM965/GM965/GL960 Memory Controller Hub (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0
Capabilities: [e0] Vendor Specific Information <?>
Kernel driver in use: agpgart-intel
Kernel modules: intel-agp
00:02.0 VGA compatible controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0, IRQ 6
Memory at f0000000 (64-bit, non-prefetchable) [size=1M]
Memory at d0000000 (64-bit, prefetchable) [size=256M]
I/O ports at 1800 [size=8]
Capabilities: [90] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable-
Capabilities: [d0] Power Management version 3
Kernel modules: intelfb
00:02.1 Display controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controller (rev 03)
Subsystem: Acer Incorporated [ALI] Device 011b
Flags: bus master, fast devsel, latency 0
Memory at f0100000 (64-bit, non-prefetchable) [size=1M]
Capabilities: [d0] Power Management version 3
and here is my xorg.conf
Section "Device"
Identifier "Configured Video Device"
EndSection
Section "Monitor"
Identifier "Configured Monitor"
EndSection
Section "Screen"
Identifier "Default Screen"
Monitor "Configured Monitor"
Device "Configured Video Device"
EndSection
Section "ServerLayout"
Identifier "Default Layout"
Screen "Default Screen"
# commented out by update-manager, HAL is now used
# InputDevice "Synaptics Touchpad"
EndSection
What shall I do to make compiz working again?