le3000gt
October 19th, 2008, 10:17 PM
this is what I get
le3000gt@le3000gt-laptop:~$ sudo kismet
Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to change channel.
Source 0 (addme): Opening none source interface none...
FATAL: Please configure at least one packet source. Kismet will not function if no packet sources are defined in kismet.conf or on the command line. Please read the README for more information about configuring Kismet.
Kismet exiting.
Done.
what I did to kismet.conf and what there now
source=type,interface,ath0
source=ipw3945,ath0,Wireless Card
then I save it and closed it
this is my iwconfig
ath0 IEEE 802.11g ESSID:"linksys" Nickname:""
Mode:Managed Frequency:2.437 GHz Access Point: 00:1C:10:10:21:F8
Bit Rate:36 Mb/s Tx-Power:17 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality=14/70 Signal level=-80 dBm Noise level=-94 dBm
Rx invalid nwid:61121 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
i
le3000gt@le3000gt-laptop:~$ sudo kismet
Launching kismet_server: //usr/bin/kismet_server
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
Enabling channel hopping.
Enabling channel splitting.
NOTICE: Disabling channel hopping, no enabled sources are able to change channel.
Source 0 (addme): Opening none source interface none...
FATAL: Please configure at least one packet source. Kismet will not function if no packet sources are defined in kismet.conf or on the command line. Please read the README for more information about configuring Kismet.
Kismet exiting.
Done.
what I did to kismet.conf and what there now
source=type,interface,ath0
source=ipw3945,ath0,Wireless Card
then I save it and closed it
this is my iwconfig
ath0 IEEE 802.11g ESSID:"linksys" Nickname:""
Mode:Managed Frequency:2.437 GHz Access Point: 00:1C:10:10:21:F8
Bit Rate:36 Mb/s Tx-Power:17 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality=14/70 Signal level=-80 dBm Noise level=-94 dBm
Rx invalid nwid:61121 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
i