View Full Version : error on exiting mythtv-setup
October 1st, 2008, 11:54 AM
Card1 (type composite1) is set to start on channel Please add, which does not exist
Card1 (type S-video1) is set to start on channel Please add, which does not exist
Do you want to fix these problems?
selecting yes does not fix the problem, select no exits and whentrying to watch TV, I get a black screen.
this is a avc-2010 capture card with svideo and composite inputs
the card is working with VLC streaming
October 1st, 2008, 12:15 PM
I assume you've scanned for channels and that setup has retrieved the channels ok. You need to go into Input Connections (I think that's what it's called) and tell setup which channel the card should start on.
October 1st, 2008, 05:30 PM
well the problem is, this is not a tuner card.
But supposedly this is supported in mythtv.
It is a video capture card only.
All it does is take either svideo or composite input with left and right audio.
Anyway I can use VLC to capture the stream and even record a show from a vcr tuner.
Do you think this issue of a channel setting is stopping it from working?
Any I dont see how you would set a channel
this is my capture card
05:0a.0 Multimedia video controller: Internext Compression Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
March 14th, 2009, 01:58 AM
I am experiencing the same problem with a Brooktree BT848 capture card. Did you find a workaround?
December 28th, 2009, 11:45 AM
Was this ever resolved?
December 30th, 2009, 12:05 AM
no, I never did figure it out.
I simply use VLC to open the card
and I can record using vlc, select advanced controls and you get a red record button
December 30th, 2009, 11:49 AM
I asked this question on the mythtv-users forum
Here is the response
Powered by vBulletin® Version 4.2.2 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.