liksys USB200M network adapter problems

[lateralus01]

I have a linksys USB200M fast ethernet adapter and I just can't seem to get it to work. I looked on the web and the modules I found are usbnet and axnet-cs. I built both of them as modules in the kernel.
then I ran:

modprobe usbnet
modprobe axnet_cs

they both worked fine without any errors and i checked and the adapter is detected:


Master ~ # lsusb
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
Bus 001 Device 002: ID 045e:0288 Microsoft Corp. Xbox Controller S Hub
Bus 001 Device 005: ID 045e:0289 Microsoft Corp. Xbox Controller S
Bus 001 Device 006: ID 13b1:0018 Linksys USB200M 10/100 Ethernet Adapter


but nothing is shown when I run ifconfig:


Master ~ # ifconfig
eth0 Link encap:Ethernet HWaddr 00:0D:3A:BF:6B:B4
inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20d:3aff:febf:6bb4/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3435 errors:0 dropped:0 overruns:0 frame:0
TX packets:1111 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:318973 (311.4 Kb) TX bytes:158037 (154.3 Kb)
Interrupt:4 Base address:0x5000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)


There should be an interface called usb0 but it's obviously not there.

What should I do?

Thanks,
Lateralus01