pD43WfR
November 17th, 2018, 03:52 PM
Hello there!
I was going to install Ubuntu 18.10 in a multi-boot configuration, where I also have another Linux distro installed. I have an SSD drive that I wanted to dedicate to my Ubuntu installation.
I went to create an efi/ext4/swap setup for that SSD as shown here (apologies if the image is a bit big):
https://i.imgur.com/r3gDv9e.jpg
However, when I went to click "Install Now" it wants to use a different swap partition from /dev/sda AS WELL as the one I created as shown here:
https://i.imgur.com/lHs6K7k.jpg
I'm sure this isn't what I want. I have a Manjaro installation on /dev/sda as shown here:
https://i.imgur.com/opwne5N.jpg
Is there any way to make the installation do what I want?
I was going to install Ubuntu 18.10 in a multi-boot configuration, where I also have another Linux distro installed. I have an SSD drive that I wanted to dedicate to my Ubuntu installation.
I went to create an efi/ext4/swap setup for that SSD as shown here (apologies if the image is a bit big):
https://i.imgur.com/r3gDv9e.jpg
However, when I went to click "Install Now" it wants to use a different swap partition from /dev/sda AS WELL as the one I created as shown here:
https://i.imgur.com/lHs6K7k.jpg
I'm sure this isn't what I want. I have a Manjaro installation on /dev/sda as shown here:
https://i.imgur.com/opwne5N.jpg
Is there any way to make the installation do what I want?