gary47
September 24th, 2014, 10:22 PM
I have the ROM set, I have the Net Card set for g but cannot get it to Wake.. I changed drivers from r8169 to r8168 but still no luck
sudo lshw -C network Gives you
*-network
description: Ethernet interface
product: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:04:00.0
logical name: eth0
version: 02
serial: 00:21:70:4d:fa:d3
size: 100Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list rom ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8168 driverversion=8.039.00-NAPI duplex=full ip=192.168.0.102 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
resources: irq:44 ioport:e800(size=256) memory:febff000-febfffff memory:f8ff0000-f8ffffff memory:febc0000-febdffff
sudo ethtool eth0 Gives you
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
sudo lspci -v
04:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 02)
Subsystem: Dell Device 02ac
Physical Slot: 0-2
Flags: bus master, fast devsel, latency 0, IRQ 44
I/O ports at e800 [size=256]
Memory at febff000 (64-bit, non-prefetchable) [size=4K]
Memory at f8ff0000 (64-bit, prefetchable) [size=64K]
Expansion ROM at febc0000 [disabled] [size=128K]
Capabilities: [40] Power Management version 3
Capabilities: [50] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Endpoint, MSI 01
Capabilities: [b0] MSI-X: Enable- Count=2 Masked-
Capabilities: [d0] Vital Product Data
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Virtual Channel
Capabilities: [160] Device Serial Number 00-e0-4c-68-00-00-00-03
Kernel driver in use: r8168
Kernel modules: r8168
Anybody have any clues what I am doing wrong?? I am new to Ubuntu and really don't know where to go from here...
sudo lshw -C network Gives you
*-network
description: Ethernet interface
product: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:04:00.0
logical name: eth0
version: 02
serial: 00:21:70:4d:fa:d3
size: 100Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list rom ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8168 driverversion=8.039.00-NAPI duplex=full ip=192.168.0.102 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
resources: irq:44 ioport:e800(size=256) memory:febff000-febfffff memory:f8ff0000-f8ffffff memory:febc0000-febdffff
sudo ethtool eth0 Gives you
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
sudo lspci -v
04:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 02)
Subsystem: Dell Device 02ac
Physical Slot: 0-2
Flags: bus master, fast devsel, latency 0, IRQ 44
I/O ports at e800 [size=256]
Memory at febff000 (64-bit, non-prefetchable) [size=4K]
Memory at f8ff0000 (64-bit, prefetchable) [size=64K]
Expansion ROM at febc0000 [disabled] [size=128K]
Capabilities: [40] Power Management version 3
Capabilities: [50] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Endpoint, MSI 01
Capabilities: [b0] MSI-X: Enable- Count=2 Masked-
Capabilities: [d0] Vital Product Data
Capabilities: [100] Advanced Error Reporting
Capabilities: [140] Virtual Channel
Capabilities: [160] Device Serial Number 00-e0-4c-68-00-00-00-03
Kernel driver in use: r8168
Kernel modules: r8168
Anybody have any clues what I am doing wrong?? I am new to Ubuntu and really don't know where to go from here...