How to run transmission-daemon on a secondary interface

[sona1111]

(i think i put this in the wrong category, sorry for repost)

I have a web/file/halo/etc server going with a main fast connection, and i also have a slower connection that i want to make use of. (two separate modems) So basically i want every single thing on the server to use one interface EXCEPT transmission-daemon, which i want to use the other. i also want remote connections to go through the main interface, only the traffic itself goes through the secondary. (both already have static ips)

Transmission looks like it has this all good to go in its settings.json file, where you can set a bind ip for both the remote and regular connections. However, changing it to the ip of the other connection does nothing, it just uses the main connection. (even after restarting the daemon, yes)

I have heard you need to mess with iptables or something to get this to work, but i could not find a tutorial applying to transmission. can anyone tell me how to do this?

thanks for reading.

[sona1111]

bump

[sona1111]

also how do i delete posts? like the useless "bump" ones?

[sona1111]

bump

[papibe]

Hi sona1111.

I've never done this, but there is a way to 'bind' transmission-daemon to a particular IP address. Since you have to connections, I imagine you'll have 2 public IPs.

From transmission's man page:

-i --bind-address-ipv4
Listen for IPv4 BitTorrent connections on a specific address.
Only one IPv4 listening address is allowed. Default: 0.0.0.0 (All
addresses)


Also, take a look at this thread (http://ubuntuforums.org/showthread.php?t=1472045&highlight=transmission+vpn) as an example. It is not exactly your case, but it does use of the binding functionality (in this case to a VPN).

I hope that points you in the right direction.
Regards.

[sona1111]

i have tried that bind address setting many times in a frustratingly large number of test configurations. it either does not transfer at all or just transfers on the other connection.

[sona1111]

bump

[sona1111]

If anyone else ende up reading this thread, i finally got it today.

follow the first half of this guide (everything before load balancing): http://lartc.org/howto/lartc.rpdb.multiple-links.html

MY problem was that in the "ip network" ($P1_NET in the guide) i put 192.168.3.0 when it should have been 192.168.3.0/24. Dont forget the CIDR.

thank you for anyone else who tried to help.

[SirKingChase]

I patched transmission-daemon with https://trac.transmissionbt.com/ticket/2313

Now all I have to do is screw around with the routing tables to get Wlan0 to receive back requests.

I cant figure out how to do this. Its so hard and confusing.

If you have two interfaces linux routes all traffic from the second one through the first one but default.

I want all requests that are on Wlan0, to stay with Wlan0
I want all Eth0 requests to stay with Eth0.

I do not want the data from Wlan0 to get routed through Eth0

This guy details it exactly how I want it.... I followed his guide and it doesnt work

http://kindlund.wordpress.com/2007/11/19/configuring-multiple-default-routes-in-linux/

Found this guide that is easier to read and basically does the same thing..... doesnt work

http://www.rjsystems.nl/en/2100-adv-routing.php

Just for giggles ( I needed a break after working on the above ALL DAY ) I tried my hand at bonding

https://help.ubuntu.com/community/UbuntuBonding

....Crashed and burned there as well