BURG terminal command mistake

[sks24]

I, uh, copied the command "sudo burg-install "(hd0)" from here (http://www.unixmen.com/how-to-install-burg-in-ubuntu/) but forgot to substitute the correct disk for the MBR before I hit "Enter." "sudo fdisk -l" result below:


ronald@ronald-OptiPlex-GX620:~$ sudo burg-install "(hd0)"
Installation finished. No error reported.
ronald@ronald-OptiPlex-GX620:~$ sudo fdisk -l

Disk /dev/sda: 80.0 GB, 80000000000 bytes
255 heads, 63 sectors/track, 9726 cylinders, total 156250000 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x7a994666

Device Boot Start End Blocks Id System
/dev/sda1 * 2048 411647 204800 7 HPFS/NTFS/exFAT
/dev/sda2 411648 132632639 66110496 7 HPFS/NTFS/exFAT
/dev/sda3 132634622 156248063 11806721 5 Extended
/dev/sda5 132634624 152076287 9720832 83 Linux
/dev/sda6 152078336 156248063 2084864 82 Linux swap / Solaris
ronald@ronald-OptiPlex-GX620:~$

Can I continue safely with "sudo update-burg"? Should I re-issue:

sudo burg-install "(hd0)"

If so, what should I say instead of "(hd0)">?

This is a 12.04 32 bit installation alongside Win7

Thanks in advance,
Scott

[wilee-nilee]

The command is

sudo burg-install /dev/sda
Then

sudo update-burg

[sks24]

Workidid lika charm, wilee-nilee! Thanks!

[wilee-nilee]

Workidid lika charm, wilee-nilee! Thanks!

No problem, notice with grub 2 partitions are sdX and sdXX, and some times is preceded by a /dev.

Burg is actually grub 2 with added visual stuff, or at least one of the grub 2 releases.

[sks24]

Noted, & thanks again,
S