View Full Version : [ubuntu] XSane failed to open
dennisofnewport
April 26th, 2012, 09:12 PM
Xsane
can any one help me change the argument in xsane
when I run xsane i get the following message
failed to open device brothers3:bus3;dev1' invalid argument
when I run lsusb I see brothers listed as bus1 device 2
can I change this agrument in xsane????
thanks
col48
April 26th, 2012, 09:53 PM
Does this help?
http://askubuntu.com/questions/32646/how-to-change-the-bus-dev-in-order-to-allow-xsane-to-work
I imagine that if you
cd /dev/bus/usb/001 you see an entry 002 which you can identify with the scanner (my equivalent has the owner lp - line printer - and it is an MFP)
The chmod suggested adds write access for you to the entry. I don't understand why this might change the device bus address but perhaps you do! If the error was 'access denied' then this solution would be more reasonable to me, pedant that I am!
This is on the same lines and a bit more readable:
http://www.scribd.com/doc/44744453/XSANE-permissions
Alternatively...
http://ubuntuforums.org/showthread.php?t=1285100
gives an explanation of why your situation might have happened and perhaps a different way through.
Hope you find a solution.
dennisofnewport
May 1st, 2012, 06:52 PM
thanks for the info I tried them and still a little confused. I want to change xsane to reckon the correct bus an dev. How do I get into xsane.
dennisofnewport
May 2nd, 2012, 01:43 AM
thanks I still do not know how to mark this thread a solved but it is.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.