fcodvpt
October 19th, 2011, 08:44 PM
Hi,
Since the upgrade 11.04 => 11.10 on Sunday, my printer (Canon MG 5150) is not available.
In the printer properties, I have the following message if I try to print a test page :
Printer cable not connected or printer power off; will retry in 30 seconds...
Here is what appear with dmesg when I power the printer on :
$ dmesg
...
[ 59.728061] usb 1-2: new high speed USB device number 5 using ehci_hcd
[ 59.866122] scsi8 : usb-storage 1-2:1.2
[ 60.865977] scsi 8:0:0:0: Direct-Access Canon MG5100 series 0101 PQ: 0 ANSI: 2
[ 60.936259] sd 8:0:0:0: Attached scsi generic sg6 type 0
[ 60.942146] sd 8:0:0:0: [sdf] Attached SCSI removable disk
[ 61.281092] usb 1-2: usbfs: interface 2 claimed by usb-storage while 'usb' sets config #1
[ 61.282553] usb 1-2: usbfs: process 2117 (usb) did not claim interface 0 before use
The upgrades have not solved the problem.
Any suggestion ?
Regards
Since the upgrade 11.04 => 11.10 on Sunday, my printer (Canon MG 5150) is not available.
In the printer properties, I have the following message if I try to print a test page :
Printer cable not connected or printer power off; will retry in 30 seconds...
Here is what appear with dmesg when I power the printer on :
$ dmesg
...
[ 59.728061] usb 1-2: new high speed USB device number 5 using ehci_hcd
[ 59.866122] scsi8 : usb-storage 1-2:1.2
[ 60.865977] scsi 8:0:0:0: Direct-Access Canon MG5100 series 0101 PQ: 0 ANSI: 2
[ 60.936259] sd 8:0:0:0: Attached scsi generic sg6 type 0
[ 60.942146] sd 8:0:0:0: [sdf] Attached SCSI removable disk
[ 61.281092] usb 1-2: usbfs: interface 2 claimed by usb-storage while 'usb' sets config #1
[ 61.282553] usb 1-2: usbfs: process 2117 (usb) did not claim interface 0 before use
The upgrades have not solved the problem.
Any suggestion ?
Regards