View Full Version : [SOLVED] Ubuntu Minimal 10.04 Installation DHCP Fail
ruimarto
May 23rd, 2011, 01:26 AM
During the Ubuntu Minimal 10.04, 10.10 or XBMC Live (Ubuntu 10.04) I get a DHCP automatic configuration fail. If I change to manual and put the IP, gateway, mask and DNS servers, the installation goes fine but when I boot I don't have a connection.
Installing Ubuntu minimal 11.04 everything works.
What could be the problem?
My system is an Asus AT5IONT-i and it's connected by wire to my router. I've double checked the cable and the router and all seams fine.
linuxinstalledfromhdd
May 23rd, 2011, 02:23 AM
are you using the alternative installation disc for Ubuntu?
ruimarto
May 23rd, 2011, 02:35 AM
I'm using a USB pen with 64bit Ubuntu 10.04 Lucid Lynx minimal that I downloaded from here:
https://help.ubuntu.com/community/Installation/MinimalCD
During the install I get:
Network autoconfiguration failed
Your network is probably not using the DHCP protocol. Alternatively, the DHCP server may be slow or some network hardware is not working properly.
If I configure manually, installation goes well. When I then boot into the system, problem returns and there's no network connectivity. I tried to edit /etc/network/interfaces to static with IP, gateway and mask below, and no luck.
linuxinstalledfromhdd
May 23rd, 2011, 02:58 AM
what kind of protocol does the router use for this connection?
ruimarto
May 23rd, 2011, 03:03 AM
What do you mean? It's a regular router (DIR-825) so I guess it uses TCP/IP...
linuxinstalledfromhdd
May 23rd, 2011, 03:13 AM
Static IP?
ruimarto
May 23rd, 2011, 03:16 AM
Yes. I've fixed IPs for every machine in my network. But DHCP is on. And like I said, with 11.04 version, everything works fine.
I've done:
sudo ifdown eth0
sudo ifup eth0
And got a message saying OpenSSH was running. After reboot it went down again. And apt-get update not working either.
ruimarto
August 2nd, 2011, 04:12 PM
I've used the jumper on the board to clear the BIOS and looks like it's fixed.
dino99
August 2nd, 2011, 04:17 PM
So now please use the "Thread Tools" on top to mark it as SOLVED
ruimarto
August 9th, 2011, 05:24 AM
Done! :D sorry I forgot
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.