coldasice
May 22nd, 2011, 01:39 AM
Hello all, i`m new to linux, and i`m tryin` to config my kismet conf file cuz i get this message
FATAL: Please configure at least one packet source. Kismet will not function if no packet sources are defined in kismet.conf or on the command line
i`ve googled few tutorials but cannot figure out what i should type there , i use Atheros 9285 , my wifi interface is wlan0 as u can see :
Interface Chipset Driver
wlan0 Atheros ath9k - [phy0]
i know it should look like this : source=iwl3945,eth1,eth1 or source=madwifi_ag,wifi0,madwifi
i`ve tried and changed for with my ath , wlan0 , but it still wont work, soo please tell me what i should type in those three lines after source= and what does it mean each .and if you could tell me how to determine what to type there or where does it say what to put there. thanks alot
FATAL: Please configure at least one packet source. Kismet will not function if no packet sources are defined in kismet.conf or on the command line
i`ve googled few tutorials but cannot figure out what i should type there , i use Atheros 9285 , my wifi interface is wlan0 as u can see :
Interface Chipset Driver
wlan0 Atheros ath9k - [phy0]
i know it should look like this : source=iwl3945,eth1,eth1 or source=madwifi_ag,wifi0,madwifi
i`ve tried and changed for with my ath , wlan0 , but it still wont work, soo please tell me what i should type in those three lines after source= and what does it mean each .and if you could tell me how to determine what to type there or where does it say what to put there. thanks alot