Sum Guy
May 14th, 2011, 01:41 PM
I've recently installed UEC on 2 computers, and am having problems with one of them. Despite following the installation instructions, the Walrus controller, Storage controller and Cluster controller are not registering as they should be. I tried using euca_conf to register them, with no effect. I have no idea how to apply the manual instructions for registering the controllers, as these appear to apply to multiple frontend setups. The frontend is an Athlon 64 3000+, and seems to have load averages between 1 and 2, which I would think would merely cause lag, rather than failure of a critical stage of installation. Any ideas?
EDIT: Note that I am NOT running a DNS server, instead I provided the IP address as the FQDN during installation. Is it possible to run UEC without a DNS server, and if so, have I set this up correctly?
EDIT 2: The node is also not registering, through euca_conf or automatically.
Thanks.
EDIT: Note that I am NOT running a DNS server, instead I provided the IP address as the FQDN during installation. Is it possible to run UEC without a DNS server, and if so, have I set this up correctly?
EDIT 2: The node is also not registering, through euca_conf or automatically.
Thanks.