zander1013
December 23rd, 2010, 08:47 PM
hi,
i have setup my first raid (a raid 1) using a pair of 4gb usb sticks.
i have followed the instructions here...
https://help.ubuntu.com/community/Installation/SoftwareRAID
rather than use 10.04 alternate iso i have used the 10.10 alternate iso from a third usb stick.
i am at the point "Configuring the RAID". in step 7 of this section i have done as instructed for the ext4 partitions. i have left out the swap partitions (after all they were left out of the instruction). is this correct?
also the drives appear to be syncing as described in the instruction.
the installer has taken me back to the Partition Disks installer menu. the drives appear to still be syncing should i wait until their chatter has stopped before selecting "finish"?
so the questions are should i sync the swap spaces? and when should i select "finish" in the installer?
thank you.
i have setup my first raid (a raid 1) using a pair of 4gb usb sticks.
i have followed the instructions here...
https://help.ubuntu.com/community/Installation/SoftwareRAID
rather than use 10.04 alternate iso i have used the 10.10 alternate iso from a third usb stick.
i am at the point "Configuring the RAID". in step 7 of this section i have done as instructed for the ext4 partitions. i have left out the swap partitions (after all they were left out of the instruction). is this correct?
also the drives appear to be syncing as described in the instruction.
the installer has taken me back to the Partition Disks installer menu. the drives appear to still be syncing should i wait until their chatter has stopped before selecting "finish"?
so the questions are should i sync the swap spaces? and when should i select "finish" in the installer?
thank you.