View Full Version : [ubuntu] After upgrade to 10 from 9.x Wireless fails
ESimard
November 21st, 2010, 12:57 AM
Hi, I upgraded from 9.x to 10.10. Under 9.x my wireless usb dongle worked correctly. After upgrade it does not. I checked the dongle on another machine and it works correctly. I inserted a usb memory stick and the system found it as a drive correctly. I assume from this that both the dongle and usb port are ok. The wireless device is a D-Link G122 A2 which is on the supported list (it ran out of the box on 9.x). The link light does not come on so I am assuming that the process to identify it as a wireless device is not running. If this is correct how do I proceed from here? What other steps need be taken?
Thanks in advance
_Ernie
ESimard
November 21st, 2010, 10:09 PM
Forgot to note that lsusb does show the wireless device correctly so the system knows it there.
_Ernie
mörgæs
November 22nd, 2010, 01:44 AM
This forum might help you better:
http://ubuntuforums.org/forumdisplay.php?f=336
ESimard
November 22nd, 2010, 07:35 PM
Hi, all
I will try the other form if the following doesn't yield any info.
Even though I didn't need it in ubuntu 8x or 9x, I tried installing ndiswrapper and adding the windows driver for the D-Ling G122 Rev A2. Now I get several wireless locations, so that part is working. However I cannot complete a connection. The passwords and other configurations worked previously and I did reenter them just in case but still no connect.
The logfile shows the following on each insertion of the dongle:
Nov 21 15:28:35 ernie-desktop kernel: [ 3183.428644] ndiswrapper (iw_set_auth:1602): invalid cmd 12
Nov 21 15:28:35 ernie-desktop kernel: [ 3183.428729] ndiswrapper (set_iw_auth_mode:601): setting auth mode to 7 failed (C0010015)
Nov 21 15:28:46 ernie-desktop kernel: [ 3194.727522] ndiswrapper (set_iw_auth_mode:601): setting auth mode to 7 failed (C0010015)
Any clue as to what the error mean?
ernie@ernie-desktop:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:"2WIRE183"
Mode:Managed Frequency:2.457 GHz Access Point: 00:25:3C:17:4A:29
Bit Rate=54 Mb/s Tx-Power:32 dBm
RTS thr:2432 B Fragment thr:2432 B
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Thanks Ernie
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.