teejmya
September 6th, 2010, 08:31 PM
Hello all.
I am running Fluxbox over a traditional Ubutnu 10.04 install.
I use two heads on my system via NVidia's TwinView setup.
I was wondering how TwinView delegates the two monitors?
When I run commands on DISPLAY=:0.0 it runs,
But commands on DISPLAY=:0.1 report that the display cannot be opened.
Any help on this would be appreciated.
I am running Fluxbox over a traditional Ubutnu 10.04 install.
I use two heads on my system via NVidia's TwinView setup.
I was wondering how TwinView delegates the two monitors?
When I run commands on DISPLAY=:0.0 it runs,
But commands on DISPLAY=:0.1 report that the display cannot be opened.
Any help on this would be appreciated.