strm
August 31st, 2010, 03:37 PM
Hi,
I have a setup with two 1TB drives which I would like to run in RAID1. I would also like to to have both Ubuntu Server and Windows Server on this box all residing on this 1TB array.
Is this possible and reliable? Is making Ubuntu Server run on "hardware RAID" (on-board controller) reasonable? Or does dmraid, LVM take care of the array better making it a software RAID? In which case, perhaps I can run Windows Server in a VM?
I setup the array using the controller BIOS and just added both drives to one single RAID1 array, then partitioned approximately as follows:
sda1 200gb ntfs (unused atm)
sda2 32gb swap
sda3 1gb /boot
sda5 767gb logical, rest of linux ext4
--various sizes for / /home /usr etc.
At the moment I can't seem to get Ubuntu to boot following installation.
What do you think? Hard of soft raid? Windows in VM?
I have a setup with two 1TB drives which I would like to run in RAID1. I would also like to to have both Ubuntu Server and Windows Server on this box all residing on this 1TB array.
Is this possible and reliable? Is making Ubuntu Server run on "hardware RAID" (on-board controller) reasonable? Or does dmraid, LVM take care of the array better making it a software RAID? In which case, perhaps I can run Windows Server in a VM?
I setup the array using the controller BIOS and just added both drives to one single RAID1 array, then partitioned approximately as follows:
sda1 200gb ntfs (unused atm)
sda2 32gb swap
sda3 1gb /boot
sda5 767gb logical, rest of linux ext4
--various sizes for / /home /usr etc.
At the moment I can't seem to get Ubuntu to boot following installation.
What do you think? Hard of soft raid? Windows in VM?