DVB S2 Mantis not started & no MAC

[magictails]

hi

all ok except


Skystar HD2 (b): 1822:4e35 / Subsystem: 1ae4:0003

lspc -vv

03:06.0 Multimedia controller: Twinhan Technology Co. Ltd Mantis DTV PCI Bridge Controller [Ver 1.0] (rev 01)
Subsystem: Device 1ae4:0003
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (2000ns min, 63750ns max)
Interrupt: pin A routed to IRQ 3
Region 0: Memory at fdeff000 (32-bit, prefetchable) [size=4K]

lspci -vvn

03:06.0 0480: 1822:4e35 (rev 01)
Subsystem: 1ae4:0003
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (2000ns min, 63750ns max)
Interrupt: pin A routed to IRQ 3
Region 0: Memory at fdeff000 (32-bit, prefetchable) [size=4K]


after looking in GG i tried 3 instal how to but nothing change


mutliproto , mantis drivers , v4l ,

i lost this 2 lines
Kernel driver in use: Mantis
Kernel modules: mantis


la MAc not readed

card ok with win32 on Dvbdream & BDA.dev 108

correct answser are

************************************************** *******************
dmesg

...

found a UNKNOWN PCI UNKNOWN device on (00:07.0),
Mantis Rev 1 [1ae4:0003], irq: 21, latency: 32
memory: 0xdddff000, mmio: 0xf8d3c000
MAC Address=[00:08:c9:e0:28:9e]
mantis_alloc_buffers (0): DMA=0x35d10000 cpu=0xf5d10000 size=65536
mantis_alloc_buffers (0): RISC=0x35eef000 cpu=0xf5eef000 size=1000
DVB: registering new adapter (Mantis dvb adapter)
mantis_ca_init (0): Registering EN50221 device
mantis_ca_init (0): Registered EN50221 device
mantis_hif_init (0): Adapter(0) Initializing Mantis Host Interface

ls -l /dev/dvb/adapter0

************************************

thank for advance



sorry it's not the good section for post


En ligne