pug2694328
May 1st, 2010, 03:36 PM
I am installing Ubuntu server 10 and having a little trouble booting.
I used the server install CD for partitioning as well as OS install.
During Ubuntu server setup I partitioned each of 5 1GB drives into two partitions, a small one for swap and the rest for /
I set their type to be used for RAID.
I went into the the RAID configure bit and created two RAID arrays from the 10 partitions.
I then saved that and set the smaller raid array to be used for swap and the larger to be used as /. I then continued and installed the Ubuntu server OS. Everything seemed fine, but when I rebooted at the end of install I hit this:
error: file not found
grub rescue>
when I do an ls, I am pretty sure I can see my raid arrays (md0 and md1:
(md0) (md1) (hd0,5) (hd0,1), (hd1,1) (hd1,2) (hd2,5), (hd2,1), (hd3), (hd3,5) (hd3,1) (hd4) (hd4,5) (hd4,1)
I suspect it's a problem with grub since the installer appeared to be successfully installing the OS. Any help would be greatly appreciated!
I used the server install CD for partitioning as well as OS install.
During Ubuntu server setup I partitioned each of 5 1GB drives into two partitions, a small one for swap and the rest for /
I set their type to be used for RAID.
I went into the the RAID configure bit and created two RAID arrays from the 10 partitions.
I then saved that and set the smaller raid array to be used for swap and the larger to be used as /. I then continued and installed the Ubuntu server OS. Everything seemed fine, but when I rebooted at the end of install I hit this:
error: file not found
grub rescue>
when I do an ls, I am pretty sure I can see my raid arrays (md0 and md1:
(md0) (md1) (hd0,5) (hd0,1), (hd1,1) (hd1,2) (hd2,5), (hd2,1), (hd3), (hd3,5) (hd3,1) (hd4) (hd4,5) (hd4,1)
I suspect it's a problem with grub since the installer appeared to be successfully installing the OS. Any help would be greatly appreciated!