PDA

View Full Version : [ubuntu] ATI Radeon HD 3450 - FGLRX and AIGLX



Sonybuntu
May 1st, 2010, 12:44 AM
I had the radeon drivers and when I ran compiz-check it said that AIGLX was enabled. Now that I installed the FGLRX drivers (the ones from ATI's website, not from Hardware Drivers,) it said there is no rendering method in use. How do I enable AIGLX again? Do I even need to?

I'm running Ubuntu 10.04 LTS (downloaded RC and upgraded.) My card is an ATI Radeon HD 3450 and if it helps I'm using a Dell Vostro 420.

P.S. Below is the compiz-check results.


jonathan@UBUVOSTRO:~$ compiz-check

Gathering information about your system...

Distribution: Ubuntu 10.04
Desktop environment: GNOME
Graphics chip: ATI Technologies Inc RV620 LE [Radeon HD 3450]
Driver in use: fglrx
Rendering method: None

Checking if it's possible to run Compiz on your system... [SKIP]

Checking for hardware/setup problems... [SKIP]

At least one check had to be skipped:
Error: No rendering method in use (AIGLX, Xgl or Nvidia)

Elfy
May 1st, 2010, 12:46 PM
Thread closed at OP request.