PDA

View Full Version : [kubuntu] Wireless won't setup even when "detected"



DarknessEnemy
August 15th, 2009, 09:22 AM
Hi everyone, I hope you can help me because Im getting bald from pulling my hair out of exasperation.

I followed the instructions in this thread [http://ubuntuforums.org/showthread.php?t=575785] And even when everything came out like the thread said:
(step)
4) sudo ndiswrapper -l

output should show:

netmw14x : driver installed
device ( 11AB:2A08 ) present


I try to setup my wireless but it cannot be detected. Like if it was off (yes, I checked, is on)... I go to the gtk interface from ndiswrapper it gives me a window in the beggining saying "Unable to see if hardware is present." I close it and it says "Hardware present: Yes" but I still cannot setup my wireless.

HELP!

I hope you can help me and thank you in advance ^^.

superprash2003
August 15th, 2009, 04:59 PM
post output of
1)sudo iwconfig
2)lshw -C network

DarknessEnemy
August 15th, 2009, 06:37 PM
xxx@xxx-laptop:~$ sudo iwconfig
[sudo] password for xxx:
lo no wireless extensions.

eth0 no wireless extensions.

pan0 no wireless extensions.

xxx@xxx-laptop:~$ lshw -C network
WARNING: you should run this program as super-user.
*-network UNCLAIMED
description: Ethernet controller
product: Marvell Technology Group Ltd.
vendor: Marvell Technology Group Ltd.
physical id: 0
bus info: pci@0000:02:00.0
version: 03
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list
configuration: latency=0
*-network
description: Ethernet interface
product: RTL8101E/RTL8102E PCI Express Fast Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:06:00.0
logical name: eth0
version: 01
serial: 00:e0:b8:e6:ba:d7
width: 64 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical
configuration: broadcast=yes driver=r8169 driverversion=2.3LK-NAPI ip=192.168.0.100 latency=0 module=r8169 multicast=yes
*-network DISABLED
description: Ethernet interface
physical id: 2
logical name: pan0
serial: 7e:44:1f:7e:ca:77
capabilities: ethernet physical
configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A multicast=yes

DarknessEnemy
August 16th, 2009, 02:50 AM
bump...

DarknessEnemy
August 16th, 2009, 04:39 AM
Ok, I just solve it... I just needed to restart the computer... IM sorry for the inconvenience.