steve-101
August 7th, 2009, 02:35 AM
Hi all.
I am a c++ programmer, and have been using anjuta for some time - so this question may seem a bit inane.
When installing after running configure, make etc, program targets end up in --bindir, lib targets end up in --libdir. All good.
I have a file (myprog.conf) which I need to get installed into /etc (--sysconfdir).
What is the correct way to get this type of target into my anjuta project?
Thanks!
I am a c++ programmer, and have been using anjuta for some time - so this question may seem a bit inane.
When installing after running configure, make etc, program targets end up in --bindir, lib targets end up in --libdir. All good.
I have a file (myprog.conf) which I need to get installed into /etc (--sysconfdir).
What is the correct way to get this type of target into my anjuta project?
Thanks!