Problem with dual monitor setup in jaunty

[ummmimrob]

Hello I ran into a problem after i recently upgraded to jaunty. I had my dual monitor setup with two seperate x screens but after the upgrade my secondary monitor (screen 1) is only showing up black. The courser will go over to the desktop and i can move files from one screen to the other with the mouse(cant see what im doing on the other monitor of corse). Also when the screen saver comes on it will show in both monitors. It is as if there is a layer of black on top of the desktop. I have tried to play around with all of the settings in compiz and in with my nvidia xserver settings.
Here is my xorg.conf


# nvidia-settings: X configuration file generated by nvidia-settings
# nvidia-settings: version 1.0 (buildd@crested) Sun Feb 1 20:25:37 UTC 2009

Section "ServerLayout"
Identifier "Layout0"
Screen 0 "Screen0" 1280 0
Screen 1 "Screen1" LeftOf "Screen0"
InputDevice "Keyboard0" "CoreKeyboard"
InputDevice "Mouse0" "CorePointer"
EndSection

Section "Files"
EndSection

Section "Module"
Load "dbe"
Load "extmod"
Load "type1"
Load "freetype"
Load "glx"
EndSection

Section "ServerFlags"
Option "Xinerama" "0"
EndSection

Section "InputDevice"
# generated from default
Identifier "Mouse0"
Driver "mouse"
Option "Protocol" "auto"
Option "Device" "/dev/psaux"
Option "Emulate3Buttons" "no"
Option "ZAxisMapping" "4 5"
EndSection

Section "InputDevice"
# generated from default
Identifier "Keyboard0"
Driver "kbd"
EndSection

Section "Monitor"
# HorizSync source: edid, VertRefresh source: edid
Identifier "Monitor0"
VendorName "Unknown"
ModelName "DELL E228WFP"
HorizSync 30.0 - 83.0
VertRefresh 56.0 - 75.0
Option "DPMS"
EndSection

Section "Monitor"
# HorizSync source: edid, VertRefresh source: edid
Identifier "Monitor1"
VendorName "Unknown"
ModelName "DELL 1703FP"
HorizSync 30.0 - 80.0
VertRefresh 56.0 - 76.0
Option "DPMS"
EndSection

Section "Device"
Identifier "Device0"
Driver "nvidia"
VendorName "NVIDIA Corporation"
BoardName "GeForce 9400 GT"
BusID "PCI:1:0:0"
Screen 0
EndSection

Section "Device"
Identifier "Device1"
Driver "nvidia"
VendorName "NVIDIA Corporation"
BoardName "GeForce 9400 GT"
BusID "PCI:1:0:0"
Screen 1
EndSection

Section "Screen"
Identifier "Screen0"
Device "Device0"
Monitor "Monitor0"
DefaultDepth 24
Option "TwinView" "0"
Option "metamodes" "DFP-0: nvidia-auto-select +1280+0"
SubSection "Display"
Depth 24
EndSubSection
EndSection

Section "Screen"
Identifier "Screen1"
Device "Device1"
Monitor "Monitor1"
DefaultDepth 24
Option "TwinView" "0"
Option "metamodes" "DFP-1: nvidia-auto-select +0+0"
SubSection "Display"
Depth 24
EndSubSection
EndSection




All help will be greatly appreciated!