Geez this forum is just hellbend on not wanting to let me log in ...
Anyways, first attempt :
Code:
draug@draug:~$ dmesg | tail
[ 46.596275] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[ 46.596305] Bluetooth: BNEP filters: protocol multicast
[ 46.690942] Bridge firewalling registered
[ 46.693930] pan0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
[ 46.736836] Bluetooth: SCO (Voice Link) ver 0.6
[ 46.736856] Bluetooth: SCO socket layer initialized
[ 50.933038] eth0: link down
[ 123.729264] hub 1-0:1.0: unable to enumerate USB device on port 1
[ 124.036122] usb 1-1: new full speed USB device using ohci_hcd and address 3
[ 124.289884] usb 1-1: configuration #1 chosen from 1 choice
draug@draug:~$ lsusb
Second attempt where I removed usb wireless after approx 5 sec of inactivity
Code:
draug@draug:~$ dmesg | tail
[ 410.042855] usbcore: registered new interface driver cdc_ether
[ 410.292322] usbcore: registered new interface driver rndis_host
[ 410.382679] usbcore: registered new interface driver rndis_wlan
[ 410.603079] ppdev0: registered pardevice
[ 411.092779] ppdev0: unregistered pardevice
[ 412.992398] ppdev0: registered pardevice
[ 413.128896] ppdev0: unregistered pardevice
[ 425.772124] hub 1-0:1.0: unable to enumerate USB device on port 1
[ 426.077231] usb 1-1: new full speed USB device using ohci_hcd and address 5
[ 426.351343] usb 1-1: configuration #1 chosen from 1 choice
draug@draug:~$ lsusb
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
draug@draug:~$
So the lsusb only replies when I remove usb device... and yes all my ports work properly, I tested them with a usb key and it found it immediately.. Hope this helps... and thx for the fast reply btw
Bookmarks