[SOLVED] Do I have a broadcom I don't know about?

[4lc0h0l1c]

Hello,
AFAIK my computer does not have onboard wireless. The wlan0 interface is the one I installed myself. eth0 is my wired. However, running lshw -C network results:
~$ lshw -C network
WARNING: you should run this program as super-user.
*-network:0
description: Network controller
product: BCM4306 802.11b/g Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 9
bus info: pci@0000:00:09.0
version: 02
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list
configuration: driver=b43-pci-bridge latency=64 module=ssb
*-network:1
description: Ethernet interface
product: DP83815 (MacPhyter) Ethernet Controller
vendor: National Semiconductor Corporation
physical id: 12
bus info: pci@0000:00:12.0
logical name: eth0
version: 00
serial: xx:xx:xx:xx:xx:xx
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical
configuration: broadcast=yes driver=natsemi driverversion=2.1 latency=90 maxlatency=52 mingnt=11 module=natsemi multicast=yes
*-network
description: Wireless interface
physical id: 1
logical name: wlan0
serial: xx:xx:xx:xx:xx:xx
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=ndiswrapper+rt73 driverversion=1.52+Ralink,03/08/2006, 1.00.05. ip=xx.xx.xx.xx multicast=yes wireless=IEEE 802.11g

[Ayuthia]

It does appear that you have a Broadcom card, but I can also see that you are using the RaLink drivers which appears to be working also...

What does lspci -nn show? I would think that it will show up there also if you do have one.

[mrsteveman1]

I can't think of any reason a 4306 chip would show up if there wasn't one in the system.

[4lc0h0l1c]

I am an idiot. I installed a broadcom 4306 a while ago and forgot about it.