Re: Zenwalk LILO help
EDIT: Sorry. I spaced and thought you were asking about Slackware. The following procedure might work for Zenwalk, but you will need to substitute the name of the Zenwalk kernel image for "hugesmp.s" in the boot command.
Insert your Slackware CD #1 and boot. When you get to the "boot:" prompt, use the command "hugesmp.s root=/dev/hdd1 rdinit= ro" (no quotes). This should boot you into your installed Slackware system so that your can fix LILO.
Log in as root, and then perform "lilo -M" to replace the Grub setup in the Master Boot Record with a Lilo bootloader. You should be able to remove the CD and reboot into Slackware.
If that doesn't work, I would recommend boot into Slackware (again, using the CD), log in as root, and then run "liloconfig". After running liloconfig, remember to run "lilo -M" to install your changes.
Last edited by saulgoode; June 15th, 2008 at 05:10 PM.
"We visited sixty-six islands and landed eighty-one times, wading, swimming (to shore). Most of the people were friendly and delightful; only two arrows shot at us, and only one went near -- So much for savages!" - J.C. Patterson