Results 1 to 4 of 4

Thread: No Interface Detected for Marvell Topdog (EC85) Card

  1. #1
    Join Date
    Feb 2008
    Beans
    5

    No Interface Detected for Marvell Topdog (EC85) Card

    I recently installed Hardy Heron 32-bit, and I followed the directions in this topic to set up my Marvell Topdog wireless card. As you will see from the console output, the driver is installed, but there is no interface (i.e. wlan0) for the wireless card.

    Could someone tell me how to configure an interface for the card?

    Below are some relevant console outputs:

    sudo lshw -C network
    Code:
    programmer16@ANDROMEDA:~$ sudo lshw -C network
      *-network UNCLAIMED     
           description: Ethernet controller
           product: Marvell Technology Group Ltd.
           vendor: Marvell Technology Group Ltd.
           physical id: 0
           bus info: pci@0000:08:00.0
           version: 03
           width: 32 bits
           clock: 33MHz
           capabilities: pm msi pciexpress bus_master cap_list
           configuration: latency=0
      *-network
           description: Ethernet interface
           product: RTL8101E PCI Express Fast Ethernet controller
           vendor: Realtek Semiconductor Co., Ltd.
           physical id: 0
           bus info: pci@0000:0e:00.0
           logical name: eth0
           version: 01
           serial: 00:03:25:50:5c:1d
           capacity: 1GB/s
           width: 64 bits
           clock: 33MHz
           capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
           configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.2LK duplex=half latency=0 link=no module=r8169 multicast=yes port=twisted pair
    ifconfig -a
    Code:
    programmer16@ANDROMEDA:~$ ifconfig -a
    eth0      Link encap:Ethernet  HWaddr 00:03:25:50:5c:1d  
              UP BROADCAST MULTICAST  MTU:1500  Metric:1
              RX packets:0 errors:0 dropped:0 overruns:0 frame:0
              TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:1000 
              RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
              Interrupt:220 Base address:0x8000 
    
    lo        Link encap:Local Loopback  
              inet addr:127.0.0.1  Mask:255.0.0.0
              inet6 addr: ::1/128 Scope:Host
              UP LOOPBACK RUNNING  MTU:16436  Metric:1
              RX packets:202 errors:0 dropped:0 overruns:0 frame:0
              TX packets:202 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:0 
              RX bytes:10100 (9.8 KB)  TX bytes:10100 (9.8 KB)
    lspci
    Code:
    programmer16@ANDROMEDA:~$ lspci
    00:00.0 Host bridge: ATI Technologies Inc RS690 Host Bridge
    00:01.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (Internal gfx)
    00:05.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (PCI Express Port 1)
    00:06.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (PCI Express Port 2)
    00:07.0 PCI bridge: ATI Technologies Inc RS690 PCI to PCI Bridge (PCI Express Port 3)
    00:12.0 SATA controller: ATI Technologies Inc SB600 Non-Raid-5 SATA
    00:13.0 USB Controller: ATI Technologies Inc SB600 USB (OHCI0)
    00:13.1 USB Controller: ATI Technologies Inc SB600 USB (OHCI1)
    00:13.2 USB Controller: ATI Technologies Inc SB600 USB (OHCI2)
    00:13.3 USB Controller: ATI Technologies Inc SB600 USB (OHCI3)
    00:13.4 USB Controller: ATI Technologies Inc SB600 USB (OHCI4)
    00:13.5 USB Controller: ATI Technologies Inc SB600 USB Controller (EHCI)
    00:14.0 SMBus: ATI Technologies Inc SBx00 SMBus Controller (rev 14)
    00:14.1 IDE interface: ATI Technologies Inc SB600 IDE
    00:14.2 Audio device: ATI Technologies Inc SBx00 Azalia
    00:14.3 ISA bridge: ATI Technologies Inc SB600 PCI to LPC Bridge
    00:14.4 PCI bridge: ATI Technologies Inc SBx00 PCI to PCI Bridge
    00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
    00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
    00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
    00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
    01:05.0 VGA compatible controller: ATI Technologies Inc RS690M [Radeon X1200 Series]
    01:05.2 Audio device: ATI Technologies Inc Radeon X1200 Series Audio Controller
    08:00.0 Ethernet controller: Marvell Technology Group Ltd. Unknown device 2a08 (rev 03)
    0e:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E PCI Express Fast Ethernet controller (rev 01)
    ndiswrapper -l
    Code:
    programmer16@ANDROMEDA:~$ ndiswrapper -l
    netmw14x : driver installed
    	device (11AB:2A08) present
    iwconfig
    Code:
    programmer16@ANDROMEDA:~$ iwconfig
    lo        no wireless extensions.
    
    eth0      no wireless extensions.

  2. #2
    Join Date
    Feb 2008
    Beans
    5

    Re: No Interface Detected for Marvell Topdog (EC85) Card

    bump

  3. #3
    Join Date
    Feb 2008
    Beans
    5

    Re: No Interface Detected for Marvell Topdog (EC85) Card

    Can anyone help me?

  4. #4
    Join Date
    Feb 2008
    Beans
    5

    Re: No Interface Detected for Marvell Topdog (EC85) Card

    bump

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •