I've got a haupauge nova-t usb stick for watching dvb-t. I bought that one some weeks ago and got it running under gutsy in about no time (there are lots of tutorials around here that end up to be all the same - get v4l-dvb source, make, make install, copy firmware, done). So today I upgraded to hardy and the dvb card is no longer recognized. So, I checked for the firmware, it's still there. It was even copied from /lib/firmware/2.6.22* to /lib/firmware/2.6.24*. So I recompiled v4l-dvb. Still no changes. Than I downloaded the firmware, again. And again, no changes. So that's pretty annoying. If someone has got a good advice, I would be very thankful.
dmesg (this should be something else):
[ 387.719253] usb 7-2: new high speed USB device using ehci_hcd and address 5
[ 387.808670] usb 7-2: configuration #1 chosen from 1 choice
Bus 007 Device 005: ID 2040:7070 Hauppauge