I drink TEA not COFFEE
Some progress to report with my Toshiba LT and upgrading to JJ (9.04)...
After upgrading from Hardy to JJ, my AR5007EG is working and allowing me to post this message...unbelievable...and totally awesome!!!
Gotta give it 3: for it working without ndiswrapper.
Edit/Update: Installed aircrack-ng and madwifitools through the SPM and got the AR5007EG into Monitor Mode.
Last edited by subtorn; April 15th, 2009 at 12:14 PM. Reason: Update
This fix worked for me when I did it last fall, but I had computer troubles and had to reinstall my OS. Now when I try to do it, the website linked in the OP seems to be gone. Does anyone have the file / know where I can get it? If you have the file and are willing to send it to me, say so and I will PM you my e-mail address.
There is a very good solution. Working perfectly for me and trust me, I got full speed with the ath5k modules and no more suspend on the network.
Go to http://www.ramoonus.nl/2009/03/24/li...-debian-linux/ for instructions.
But I would advice to install the 2.6.30r*{last one} (I have the 2.6.30r4) from http://kernel.ubuntu.com/~kernel-ppa/mainline/ which work very good on my laptop with that chipset.
Let me know.
Ps: Info about kernel 2.6.30 http://www.h-online.com/open/Kernel-...--/news/113090
This referenced link is 404d. Any replacement?
http://blakecmartin.googlepages.com/...-32-0.2.tar.gz
Upgrading ubuntu 8.10 with madwifi-hal-0.10.5.6-r3942-20090205 to ubuntu 9.04
I was using the madwifi-hal driver with my 8.04 - 8.10 ubuntu install, but when I upgraded to 9.04 the driver failed to function. More importantly the Ath5k fails to allow running in promiscuous mode and packet injection. The wifi works, but I am unable to use kismet and aircrack-ng with the new driver. In answer to the previous question I edited kismet.conf with the following devices activated:
source=madwifi_ag,wifi0,Atheros
The real problem maybe that I just need the source for the ath5k driver.
so I tried the following...
sudo modprobe ath5k
then...
modeprobe -l
to check if it worked. I then edited /etc/kismet/kismet.conf with the following source...
source=ath5k,wlan0,atheros
and kismet worked perfectly, I will have to work on aircrack-ng next because my wife does not see the importance of the achievment and wants me to weed the yard.
Bookmarks