Where are you getting the 28% stuff -- From the command line Im not familar with that output at all.
What is in the lscmnds subfoler??
Where are you getting the 28% stuff -- From the command line Im not familar with that output at all.
What is in the lscmnds subfoler??
There is an icon in the tray where you can click to connect to a wireless network. When I tell it to connect it starts connecting until it gets to 28% and then fails. It does this on any wireless network, not just my router.
followed all the directions step by step, but I'm still getting "No DHCPOFFERS received."
*posted a thread on my question instead -> http://ubuntuforums.org/showthread.p...80#post3592180
Last edited by nismoskys; October 21st, 2007 at 07:11 PM. Reason: posted as thread
No icon is involved in these instructions -- if your having a problem with the icon, these instuctions are not for you!
I see that you are getting no dhcp offers. What is the sgnal strength reported for your router for
iwlist scan
Code:Quality:76/100 Signal level:-47dBm Noise level:-96 dBm
anything??
I am not using the icon with these instructions. It won't connect when I follow the instructions. When I use the GUI to manually set addresses, DNS, and Gateway or if I set it to automatic, there is a Icon to click to see available wireless networks. I can see the network, but when it tries to connect it only gets to 28%.
Here is the scan
wlan0 Scan completed :
Cell 01 - Address: 00:13:46:1F:A4:3E
ESSID:"default"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.462 GHz (Channel 11)
Quality:4/100 Signal level:-93 dBm Noise level:-96 dBm
Encryption keyff
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
12 Mb/s; 24 Mb/s; 36 Mb/s; 9 Mb/s; 18 Mb/s
48 Mb/s; 54 Mb/s
Extra:bcn_int=100
Extra:atim=0
Cell 02 - Address: 00:1A:70:F6:C6:99
ESSID:"Gameserver"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.437 GHz (Channel 6)
Quality:93/100 Signal level:-36 dBm Noise level:-96 dBm
Encryption keyn
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s
12 Mb/s; 48 Mb/s
Extra:bcn_int=100
Extra:atim=0
I wish I could help you guys more, since it seems like you guys are doing everything right. Ive seen random problems like this before, and its always something I would never think to do that would fix it -- like uninstall a different package, or disable ipv6. Try disabling ipv6, not sure if this is going to help. Ive also seen some cards struggle with 64 bit wep (some driver problem) so I dont know if you are effected by this. Have you tried ascii based wep authentication:
sudo iwconfig wlan0 key s:ASCII
With WEP, are you using the first hex key??
You can set your key index with the following command:
sudo iwconfig wlan0 key [1] XXXXXXX (or s:ASCII) key [1]
dude i love you, you're now my best friend in the world!
Kevdog
Here's one for you.
I have two identical network cards. (ipw3945)
One is working A-OK.
The other is showing up in the system, but with no logical name, and no mac address. I've checked the wireless switches, bios settings for the card - and it is enabled...
Here's what I get for "lshw -C network"
*-network
description: Network controller
product: PRO/Wireless 3945ABG Network Connection
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:0b:00.0
version: 02
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list
configuration: driver=ipw3945 latency=0 module=ipw3945
*-network
description: Wireless interface
product: PRO/Wireless 3945ABG Network Connection
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:0c:00.0
logical name: eth1
version: 02
serial: 00:1b:77:60:79:85
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ipw3945 driverversion=1.2.2mp.ubuntu1 firmware=14.2 1:0 () ip=10.10.1.9 latency=0 module=ipw3945 multicast=yes wireless=IEEE 802.11g
Obviously - the bottom one is working, top is not.
Where would I even start to get a logical name assigned to this. Querying "dmesg" doesn't give me anything interesting (errors) about this card.
I've tried other forums, threads, and this is the closest one I could find relevent. ANY help at all is appreciated.
Thanks.
Bookmarks