How-to: Lightscribe under Feisty Fawn

[Peter76]

First of all, a lot of info for this howto comes from this thread: http://ubuntuforums.org/showthread.php?t=106197 , especially the post by Loveyoung.
But there's some more to it, and I thought it would be nice to have all the info in one How-To...

So here we go....

First download "Lightscribe System Software" and "Lightscribe Simple Labeler" from www.lightscribe.com .

Now, System -> Administration -> Users and Groups, and make a group "wheel" and add any users that you want to be able to use the Lightscribe software to this group.
Or in a terminal:

sudo addgroup wheel
sudo adduser username wheel

where username is the name of the user you want to add to this group.

Install alien, libpng3 and libqt3-mt through Synaptic, or in a terminal:

sudo aptitude install alien libpng3 libqt3-mt

Now in a terminal, cd to the directory where you saved the lightscribe software and issue the following command:

sudo alien -i --scripts lightscribe-1.8.13.1-linux-2.6-intel.rpm

It will quit complaing about it's license file... To solve:

sudo gunzip /usr/share/doc/lightscribeLicense.rtf.gz

Now again

sudo alien -i --scripts lightscribe-1.8.13.1-linux-2.6-intel.rpm

And it should finish its installation without trouble...

Time to install the Labeler software:

sudo alien -i lightScribeSimpleLabeler-1.4.128.1-linux-2.6-intel.rpm

Everything should now be installed under /opt/lightscribeApplications/ . To do a test run of Simple Labeler:

cd  /opt/lightscribeApplications/SimpleLabeler/
./SimpleLabeler

If it does't work, the output given here should point you in the right direction to fix it ( or post here ). I get some X errors, but they don't seem to do any harm.

You also should install Lacie Lightscribe Labeler frome here: http://www.lacie.com/support/drivers...r.htm?id=10094 . This will give you some options Simple Labeler hasn't. In a terminal, cd to the directory where you dowloaded it and:

 sudo alien -i 4L-1.0-r6.i586.rpm

To do a test run:

4L-gui

It installs a manual as well under /usr/4L/doc

Now only use the menu editor to add an entry for Simple Labeler and 4L in your Applications menu and you are done.

Hope this was helpfull and please post any comments or suggestions

Peter