I got it! Just googling and reading the whole output of sensors-detect, I was able to install lm-sensors in my nforce2 chipset! Here's how I did it:
You can see here something fishy:
Code:
Probing for `Winbond W83627HF'
Trying address 0x0290... Success!
(confidence 8, driver `w83781d')
Anyway, I found out that w83627hf is not the right module needed for the nforce2 chipset! The right one is the driver suggested below, the w83781d.
So, here's the correct output needed:
Code:
# I2C adapter drivers
i2c-nforce2
i2c-nforce2
i2c-isa
# I2C chip drivers
eeprom
w83781d
copy that to /etc/modules
then issue these commands:
Code:
$ sudo modprobe i2c-isa
$ sudo modprobe i2c-nforce2
$ sudo modprobe w83781d
$ sudo modprobe eeprom
$ sudo /etc/init.d/module-init-tools
$ sudo update-modules
Then just run this:
And it should give you something like this:
Code:
w83627hf-isa-0290
Adapter: ISA adapter
VCore 1: +1.47 V (min = +1.14 V, max = +1.55 V)
VCore 2: +1.54 V (min = +1.14 V, max = +1.55 V) ALARM
+3.3V: +3.33 V (min = +2.82 V, max = +3.79 V)
+5V: +5.05 V (min = +0.00 V, max = +0.00 V) ALARM
+12V: +12.22 V (min = +0.00 V, max = +0.00 V) ALARM
-12V: -12.53 V (min = -14.91 V, max = -14.91 V) ALARM
-5V: -5.35 V (min = -7.71 V, max = -7.71 V) ALARM
V5SB: +5.43 V (min = +0.43 V, max = +0.00 V) ALARM
VBat: +3.04 V (min = +0.00 V, max = +0.00 V) ALARM
fan1: 0 RPM (min = -1 RPM, div = 2) ALARM
fan2: 3994 RPM (min = -1 RPM, div = 2) ALARM
fan3: 0 RPM (min = 3245 RPM, div = 4) ALARM
temp1: +34°C (high = +0°C, hyst = +0°C) sensor = thermistor ALARM
temp2: +36.5°C (high = +53°C, hyst = +48°C) sensor = thermistor
temp3: +37.0°C (high = +53°C, hyst = +48°C) sensor = thermistor
vid: +1.350 V
alarms:
beep_enable:
Sound alarm disabled
eeprom-i2c-0-51
Adapter: SMBus nForce2 adapter at 5000
Memory type: DDR SDRAM DIMM
Memory size (MB): 256
Although I'm not sure if that eeprom is right in there.. and all those "alarm" messages too
Bookmarks