I have tried to get them working without asking for help.
I can see a couple of my sensors on my motherboard using "sensors" but not all. Many are not even detected.
I have run lm-sensors then restarted. I have also tried the "/etc/init.dkmod start" command without success.
Here is my sensors output, as you can see none of my fans are reporting, nor are any of my CPU cores. Suggestions?
Code:
$ sensors
nct6776-isa-0290
Adapter: ISA adapter
Vcore: +0.87 V (min = +0.00 V, max = +1.74 V)
in1: +1.83 V (min = +0.00 V, max = +0.00 V) ALARM
AVCC: +3.26 V (min = +2.98 V, max = +3.63 V)
+3.3V: +3.26 V (min = +2.98 V, max = +3.63 V)
in4: +1.48 V (min = +0.00 V, max = +0.00 V) ALARM
in5: +1.70 V (min = +0.00 V, max = +0.00 V) ALARM
in6: +0.87 V (min = +0.00 V, max = +0.00 V) ALARM
3VSB: +3.46 V (min = +2.98 V, max = +3.63 V)
Vbat: +3.38 V (min = +2.70 V, max = +3.63 V)
fan1: 0 RPM (min = 0 RPM)
fan2: 0 RPM (min = 0 RPM)
fan3: 0 RPM (min = 0 RPM)
fan4: 0 RPM (min = 0 RPM)
fan5: 0 RPM (min = 0 RPM)
SYSTIN: +41.0°C (high = +0.0°C, hyst = +0.0°C) ALARM sensor = thermistor
CPUTIN: +35.5°C (high = +80.0°C, hyst = +75.0°C) sensor = thermistor
AUXTIN: +3.5°C (high = +80.0°C, hyst = +75.0°C) sensor = thermistor
PCH_CHIP_TEMP: +0.0°C
PCH_CPU_TEMP: +0.0°C
PCH_MCH_TEMP: +0.0°C
intrusion0: ALARM
intrusion1: ALARM
beep_enable: disabled
fam15h_power-pci-00c4
Adapter: PCI adapter
power1: 44.54 W (crit = 125.19 W)
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +23.6°C (high = +70.0°C)
(crit = +70.0°C, hyst = +67.0°C)
Bookmarks