Page 183 of 203 FirstFirst ... 83133173181182183184185193 ... LastLast
Results 1,821 to 1,830 of 2026

Thread: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

  1. #1821
    Join Date
    Sep 2006
    Location
    Allentown, PA; USA
    Beans
    490
    Distro
    Kubuntu 14.04 Trusty Tahr

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    Perhaps it is the "fuse" issue. I am thinking the kernel that is with feisty is fine, whereas the one with Edgy is lacking the up to date item. I know there are fuse-utils... but I know nothign to very little about compiling things , I have about a 25% success rate of compiling programs that will run in general so I am not optimistic on that. I don't need to write to my NTFS on my laptop, so much as read it, so therefore the default ubuntu setup of fstab was probably sufficient. I'll leave the ntfs-3g there and will just avoid writing to it until I do further research.

  2. #1822
    Join Date
    May 2007
    Beans
    82
    Distro
    Ubuntu 8.04 Hardy Heron

    Talking Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    It's turns out that I had ntfs-3g installed in my distro (Ubuntu Ultimate 1.3, edgy based) but ntfs-config was not installed. I installed it and everything is happy doory.

    Thanks for all your help guys.

    Also note, I didn't have to edit the fstab file.

  3. #1823
    Join Date
    Sep 2006
    Location
    Allentown, PA; USA
    Beans
    490
    Distro
    Kubuntu 14.04 Trusty Tahr

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    For the life of me, I just could not get anything to work without warnings on my edgy machine... so I went to http://fuse.sourceforge.net/ and downloaded the latest file. I uncompressed it.
    Then I did the usual
    ./configure
    make
    sudo make install.

    Usually I have issues when installing from source.

    That went well... and I was on a roll, so I went to the ntfs-3g site, downloaded the latest tar and did the same thing. I removed "force" from my fstab entry, rebooted, and alas, the drive is automatically mounted and readable. If I mount or unmount from terminal, the warnings are gone

  4. #1824
    Join Date
    Aug 2006
    Location
    India
    Beans
    687
    Distro
    Ubuntu 10.04 Lucid Lynx

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    my usb drive no longer mount be itself... however after using pmount-hal it does mount... but there are following errors coming...

    process 3134: Applications must not close shared connections - see dbus_connection_close() docs. This is a bug in the application.

    please help...
    Powered by Ubuntu, Driven by Linux

  5. #1825
    Join Date
    Jan 2007
    Beans
    Hidden!

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    I am using Ubuntu 7.04, on my IDE+SCSI machine, I have 2K on IDE and Ubuntu on SCSI, I just downloaded ntfs-3g and ntfs-config from the reps, then I installed and rebooted and set with ntfs-config to read and write, I got the Windows drive icon on my desktop after that and it works fine now.

  6. #1826
    Join Date
    Sep 2006
    Location
    Allentown, PA; USA
    Beans
    490
    Distro
    Kubuntu 14.04 Trusty Tahr

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    Since I have edgy on my laptop and fieity on my desktop, and since I installed ntfs-3g on my feisty machine first, I though my laptop would be a no brainer. My understanding is as follows... the fuse module with the edgy package is "out of date" with ntfs-3g. Once I updated the fuse module from source, everything is fine.

    I never updated my laptop b/c I had to do a bunch of "magic" to get my wireless working and to get most of my acpi functions to work and I don't want to loose that functionality. I noticed on two desktop machines at work lost their ndiswrapper and acpi config's. One day, I'll clone my drive and then give it a try.

  7. #1827
    Join Date
    Jul 2007
    Beans
    230
    Distro
    Ubuntu 7.04 Feisty Fawn

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    hi.

    I cant get this to work when i try to install i get this error :

    czepluch@ubuntu:~$ sudo apt-get install ntfs-configIndlæser pakkelisterne... Færdig
    Opbygger afhængighedstræ
    Reading state information... Færdig
    Nogle pakker kunne ikke installeres. Det kan betyde at du har ønsket
    en umulig situation eller bruger den ustabile distribution, hvor enkelte
    pakker endnu ikke er lavet eller gjort tilgængelige.

    Siden du kan bad om en enkelt handling, kan pakken højst sandsynligt slet
    ikke installeres og du bør indsende en fejlrapport for denne pakke.
    Følgende oplysninger kan hjælpe dig med at klare situationen:

    Følgende pakker har uopfyldte afhængigheder:
    ntfs-config: Afhængigheder: libdbus-1-2 (>= 0.60) men den kan ikke installeres
    E: Ødelagte pakker

    What can i do ?

  8. #1828
    Join Date
    Sep 2006
    Location
    Allentown, PA; USA
    Beans
    490
    Distro
    Kubuntu 14.04 Trusty Tahr

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    I don't even know what language that is! I assume you use English as your primary language? There is something odd going on with your locale settings somewhere. Beyond this, am of no further use to help you other than it looks like there is a dependency problem with libdbus-1-2 (>= 0.60) On a hunch, if you don't hear back from someone more knowledgeable, open "system settings" and then "regional and language" and see what is the default language. I use KDE and not gnome, but I think these items are similar in the menu.

    I went to altavista's bablefish site and cut and paste the text in there and selected German to English and then Dutch to English. It looked like one of those. The former got me some words but it still was not translated as readable. It might be Islandic or some Scandinavian language? These are not options with the babelfish site.

    http://world.altavista.com/
    Last edited by maestrobwh1; July 13th, 2007 at 04:40 PM.

  9. #1829
    Join Date
    Feb 2006
    Location
    Brasil
    Beans
    244
    Distro
    Xubuntu 7.04 Feisty Fawn

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    I think it's danish

    Automatic online translation
    ...it's pretty bad tho (read 'boxes' as 'packages' =P)

  10. #1830
    Join Date
    Jun 2006
    Location
    Sweden
    Beans
    72
    Distro
    Hardy Heron (Ubuntu Development)

    Re: HOWTO: NTFS with read/write support using ntfs-3g (easy method)

    Quote Originally Posted by czepluch View Post
    hi.

    I cant get this to work when i try to install i get this error :

    czepluch@ubuntu:~$ sudo apt-get install ntfs-configIndlæser pakkelisterne... Færdig
    Opbygger afhængighedstræ
    Reading state information... Færdig
    Nogle pakker kunne ikke installeres. Det kan betyde at du har ønsket
    en umulig situation eller bruger den ustabile distribution, hvor enkelte
    pakker endnu ikke er lavet eller gjort tilgængelige.

    Siden du kan bad om en enkelt handling, kan pakken højst sandsynligt slet
    ikke installeres og du bør indsende en fejlrapport for denne pakke.
    Følgende oplysninger kan hjælpe dig med at klare situationen:

    Følgende pakker har uopfyldte afhængigheder:
    ntfs-config: Afhængigheder: libdbus-1-2 (>= 0.60) men den kan ikke installeres
    E: Ødelagte pakker

    What can i do ?
    Try

    LANG=C sudo aptitude install ntfs-config
    Ubuntu Lucid on a Dell XPS M1710 - Intel Core Duo T2600 (2.16 GHz) - 4Gb RAM - 200Gb@7200rpm - GeForce Go 7900 GTX

Page 183 of 203 FirstFirst ... 83133173181182183184185193 ... LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •