Results 1 to 2 of 2

Thread: Howto: Install a Mustek ScanExpress A3 USB Scanner

Hybrid View

  1. #1
    Join Date
    Apr 2011

    Post Howto: Install a Mustek ScanExpress A3 USB Scanner

    First, check to make sure that the scanner has been detected on the usb bus. Look for a line like Bus 005 Device 005: ID 055f:0210 Mustek Systems, Inc. ScanExpress A3 USB

    sudo lsusb -v >usb.txt
    Note: this outputs the contents to a file called usb.txt in the directory you run the command from.

    If you just plug in your Mustek scanner and run SimpleScan, you might be able to select the Mustek scanner and ask it to scan something but you'll get an error message telling you that SimpleScan is unable to connect to the scanner. The reason is that the scanner needs its firmware downloading into it before it will work and this isn't being done.

    Here are the steps that I took (based on other helpful posts) to get my Mustek ScanExpress A3 scanner working.

    First, ensure that SANE is installed.

    sudo apt-get install sane
    Then check to see if the gt68xx directory exists.

    cd /user/share/sane/gt68xx
    If it doesn't and only the sane directory exists, you'll need to create it.

    sudo mkdir /user/share/sane/gt68xx
    Make sure that you're in the directory and then download the scanner firmware. You can find the full list at this site.

    sudo wget
    There are no manual edits required for this scanner, so you don't need to make any changes to /etc/sane.d/gt68xx.conf

    If you start up your scanning application like SimpleScan, you should find that it now works. The first time you do a scan after powering up the scanner may take a while. It will sit there thinking (looking like its hung) while it uploads the firmware. Subsequent scans will start quicker (until the scanner loses power again).
    Last edited by dplmartin; August 9th, 2013 at 12:48 PM. Reason: Added extra note about first time scan.

  2. #2
    Join Date
    Nov 2013

    Re: Howto: Install a Mustek ScanExpress A3 USB Scanner

    I needed to create the directory at
    sudo mkdir /usr/share/sane/gt68xx, ie usr not user. Same for cd.
    My Mustek A3 scanner is now working. Thanks very much for the how to.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts