Hi
everyone out there
i'm quite new to linux, i'm using ubuntu 12.04.
can anyone tell how to use usbmodswitch command in ubuntu coz i dont know how to use it ? I'm tring to install datacard in ubuntu 12.04.
on my terminal i type following command :
Command : usb_modeswitch -W
Result efaultVendor= not set
DefaultProduct= not set
TargetVendor= not set
TargetProduct= not set
TargetClass= not set
TargetProductList=""
DetachStorageOnly=0
HuaweiMode=0
SierraMode=0
SonyMode=0
QisdaMode=0
GCTMode=0
KobilMode=0
SequansMode=0
MobileActionMode=0
CiscoMode=0
MessageEndpoint= not set
MessageContent=""
NeedResponse=0
ResponseEndpoint= not set
InquireDevice enabled (default)
Success check disabled
System integration mode disabled
No default vendor/product ID given. Aborting.
Than i type the command
usb_modeswitch -v
Result :usb_modeswitch: option requires an argument -- 'v'
Every command with usbmodeswitch give similar type of error
can any body tell me what are the parameter for usb_modeswitch ;?
how to use mode switch ?
how to set defautl vendor ?
The output of lsusb command is followind
Command : lsusb
Result :
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 002: ID 04f2:b159 Chicony Electronics Co., Ltd
Bus 003 Device 002: ID 03f0:231d Hewlett-Packard
Bus 002 Device 006: ID 12d1:1506 Huawei Technologies Co., Ltd. E398 LTE/UMTS/GSM Modem/Networkcard
Bookmarks