Hey
Got a USB DVB-T tuner, which is supported by the Kernel, installed the firmware from a guide I found here on the forums, all good, as you can see:
Code:
dmesg |grep it913x
[ 26.187128] it913x: Chip Version=02 Chip Type=9135
[ 26.187498] it913x: Firmware Version 52953344
[ 26.187873] it913x: Dual mode=0 Tuner Type=38
[ 26.187874] it913x: Unknown tuner ID applying default 0x60
[ 26.355615] it913x-fe: ADF table value :00
[ 26.359435] it913x-fe: Crystal Frequency :12000000 Adc Frequency :20250000 ADC X2: 01
[ 26.394994] it913x-fe: Tuner LNA type :60
[ 26.879510] Registered IR keymap rc-it913x-v1
[ 26.879641] it913x: DEV registering device driver
[ 26.879661] usbcore: registered new interface driver it913x
[ 4942.583145] it913x: Chip Version=02 Chip Type=9135
[ 4942.583518] it913x: Firmware Version 52953344
[ 4942.583892] it913x: Dual mode=0 Tuner Type=38
[ 4942.583893] it913x: Unknown tuner ID applying default 0x60
[ 4942.584776] it913x-fe: ADF table value :00
[ 4942.588509] it913x-fe: Crystal Frequency :12000000 Adc Frequency :20250000 ADC X2: 01
[ 4942.624069] it913x-fe: Tuner LNA type :60
[ 4942.757262] Registered IR keymap rc-it913x-v1
[ 4942.757336] it913x: DEV registering device driver
My problem is that I cant find any channels, with any app, tried MeTV, w_scan and Kaffeine. None can get any channels. Actually, w_scan stops at some point with an error. I even installed official drivers and software in Windows and there it couldn't find anything either.
Now, I'm not using an antenna, I have Cable (DVB-C) hooked to a receiver, which has a RF out, from which you can get about 30+ analog channels with DVB-T settings.
I know this because I tried to scan using my TV, with the following settings, country=Germany, source=DVB-T, Scan for analog channels=Yes. And it finds 30+ analog channels, also, an old CRT TV finds the same channels.
This should work, so why can't this tuner find any channels?
Bookmarks