Wired Connection not connecting to router

[SeanW95]

Hello I've recently installed ubuntu on a 20GB partition using the windows based installer. I booted up and It won't connect to my network( Ethernet direct to router/modem AIO unit.)I've been talking in the IRC which had alot of help but no solutions. Any help?

To give a little background I like to think I'm quite proficient in the windows environment and currently on my last year studying a BTEC IT course (Level 3 extended diploma) and this is my first time on linux without suppourt from a tutor. I wanted to get a feel for linux and have very little knowledge of linux.
I'm running Ubuntu 12.10

EDIT: Information such as ifconfig is in the posts below!

[SeanW95]

Edit : installed without wubi still same error. It says connected but I can't ping my router

[Warren Hill]

There are lots of reasons for possible problems and we need more to go on
open a terminal (CTRL+ALT+T) and enter the following it may give us a clue

lsb_release -a; uname -a; sudo lshw -C network; ifconfig; route -n; cat \etc\network\interfaces

Post all the results back here and we may be able to advise further

[SeanW95]

As you requested.
Lsb_Release -a

sean@sean-ubuntu:~$ lsb_release -a
No LSB modules are available.
Distributor ID:	Ubuntu
Description:	Ubuntu 12.10
Release:	12.10
Codename:	quantal

uname -a

sean@sean-ubuntu:~$ uname -a
Linux sean-ubuntu 3.5.0-17-generic #28-Ubuntu SMP Tue Oct 9 19:31:23 UTC 2012 x86_64 x86_64 x86_64 GNU/Linux

ifconfig

sean@sean-ubuntu:~$ ifconfig
eth0      Link encap:Ethernet  HWaddr bc:5f:f4:08:03:6c  
          inet addr:192.168.0.25  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::be5f:f4ff:fe08:36c/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:37 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:7345 (7.3 KB)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:427 errors:0 dropped:0 overruns:0 frame:0
          TX packets:427 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:34320 (34.3 KB)  TX bytes:34320 (34.3 KB)

route -n

sean@sean-ubuntu:~$ route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0        0 eth0
169.254.0.0     0.0.0.0         255.255.0.0     U     1000   0        0 eth0
192.168.0.0     0.0.0.0         255.255.255.0   U     1      0        0 eth0

[Warren Hill]

Looking good so far. Try

ping -c5 192.168.0.1; ping -c5 8.8.8.8

[SeanW95]

Does it make any difference that my motherboard is a Nforce 630a chipset? and here are my ping results.

sean@sean-ubuntu:~$ ping 0c5 192.168.0.1
ping: unknown host 0c5
sean@sean-ubuntu:~$ ping 192.168.0.1 -c5
PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data.
From 192.168.0.25 icmp_seq=1 Destination Host Unreachable
From 192.168.0.25 icmp_seq=2 Destination Host Unreachable
From 192.168.0.25 icmp_seq=3 Destination Host Unreachable
From 192.168.0.25 icmp_seq=4 Destination Host Unreachable
From 192.168.0.25 icmp_seq=5 Destination Host Unreachable

--- 192.168.0.1 ping statistics ---
5 packets transmitted, 0 received, +5 errors, 100% packet loss, time 3999ms
pipe 3
sean@sean-ubuntu:~$ ping 8.8.8.8 -c5
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
From 192.168.0.25 icmp_seq=1 Destination Host Unreachable
From 192.168.0.25 icmp_seq=2 Destination Host Unreachable
From 192.168.0.25 icmp_seq=3 Destination Host Unreachable
From 192.168.0.25 icmp_seq=4 Destination Host Unreachable
From 192.168.0.25 icmp_seq=5 Destination Host Unreachable

--- 8.8.8.8 ping statistics ---
5 packets transmitted, 0 received, +5 errors, 100% packet loss, time 3999ms
pipe 3