Results 1 to 2 of 2

Thread: Silicom PXG4U Cannot Recognise all 4 Ethernet ports

  1. #1
    Join Date
    Nov 2005
    Location
    Athens,Greece-Oslo,Norway
    Beans
    358
    Distro
    Kubuntu

    Silicom PXG4U Cannot Recognise all 4 Ethernet ports

    I just bought Silicom PXG4U Quad Port Gigabit Ethernet and installed it in a simple PCI slot (The is no PCI-X slot on the motherboard). The system is running Ubuntu Natty 11.04 64bit server and it will only recognize 2/4 ethernet ports.

    Anyone know how to possibly solve the problem?

    This is the dmesg output of the system boot when load the module:

    Code:
    [    2.810786] tg3 0000:04:04.0: phy probe failed, err -19
    [    2.813608] tg3 0000:04:04.0: Problem fetching invariants of chip, aborting
    [    2.813632] tg3 0000:04:04.0: PCI INT A disabled
    [    2.813655] tg3 0000:04:04.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19
    [    2.932450] tg3 0000:04:04.1: phy probe failed, err -19
    [    2.935374] tg3 0000:04:04.1: Problem fetching invariants of chip, aborting
    [    2.935398] tg3 0000:04:04.1: PCI INT B disabled
    [    2.935418] tg3 0000:04:06.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
    [    3.101027] tg3 0000:04:06.0: eth1: Tigon3 [partno(BCM95704A6) rev 2100] (PCIX:133MHz:64-bit) MAC address 00:e0:ed:04:bd:6e
    [    3.101031] tg3 0000:04:06.0: eth1: attached PHY is 5704 (10/100/1000Base-T Ethernet) (WireSpeed[1])
    [    3.101034] tg3 0000:04:06.0: eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
    [    3.101037] tg3 0000:04:06.0: eth1: dma_rwctrl[769f4000] dma_mask[64-bit]
    [    3.101061] tg3 0000:04:06.1: PCI INT B -> GSI 16 (level, low) -> IRQ 16
    [    3.243735] tg3 0000:04:06.1: eth2: Tigon3 [partno(BCM95704A6) rev 2100] (PCIX:133MHz:64-bit) MAC address 00:e0:ed:04:bd:6f
    [    3.243739] tg3 0000:04:06.1: eth2: attached PHY is 5704 (10/100/1000Base-T Ethernet) (WireSpeed[1])
    [    3.243742] tg3 0000:04:06.1: eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
    [    3.243745] tg3 0000:04:06.1: eth2: dma_rwctrl[769f4000] dma_mask[64-bit]
    and this is the lspci -vv output:

    Code:
    04:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10)
            Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
            Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
            Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
            Interrupt: pin A routed to IRQ 20
            Region 0: Memory at dfdf0000 (64-bit, non-prefetchable) [size=64K]
            Capabilities: [40] PCI-X non-bridge device
                    Command: DPERE- ERO+ RBC=512 OST=1
                    Status: Dev=04:04.0 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz-
            Capabilities: [48] Power Management version 2
                    Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-)
                    Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
            Capabilities: [50] Vital Product Data
    pcilib: sysfs_read_vpd: read failed: Connection timed out
                    Not readable
            Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+
                    Address: a547a199970e8370  Data: 14d7
            Kernel modules: tg3
    
    04:04.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10)
            Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
            Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
            Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
            Interrupt: pin B routed to IRQ 19
            Region 0: Memory at dfde0000 (64-bit, non-prefetchable) [size=64K]
            Capabilities: [40] PCI-X non-bridge device
                    Command: DPERE- ERO+ RBC=512 OST=1
                    Status: Dev=04:04.1 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz-
            Capabilities: [48] Power Management version 2
                    Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-)
                    Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
            Capabilities: [50] Vital Product Data
    pcilib: sysfs_read_vpd: read failed: Connection timed out
                    Not readable
            Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+
                    Address: 30c48aea3ff5e3d0  Data: 1093
            Kernel modules: tg3
    
    04:06.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10)
            Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
            Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
            Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
            Latency: 64 (16000ns min), Cache Line Size: 4 bytes
            Interrupt: pin A routed to IRQ 18
            Region 0: Memory at dfdd0000 (64-bit, non-prefetchable) [size=64K]
            Capabilities: [40] PCI-X non-bridge device
                    Command: DPERE- ERO+ RBC=512 OST=1
                    Status: Dev=04:06.0 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz-
            Capabilities: [48] Power Management version 2
                    Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-)
                    Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
            Capabilities: [50] Vital Product Data
                    Product Name: Broadcom NetXtreme Gigabit Ethernet Controller
                    Read-only fields:
                            [PN] Part number: BCM95704A6
                            [EC] Engineering changes: 106679-15
                            [SN] Serial number: 0123456789
                            [MN] Manufacture ID: 31 34 65 34
                            [RV] Reserved: checksum bad, 26 byte(s) reserved
                    Read/write fields:
                            [YA] Asset tag: XYZ01234567
                            [RW] Read-write area: 107 byte(s) free
                    End
            Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+
                    Address: f9d56e4ebef4a5d4  Data: d7c7
            Kernel driver in use: tg3
            Kernel modules: tg3
    
    04:06.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet (rev 10)
            Subsystem: Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet
            Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
            Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
            Latency: 64 (16000ns min), Cache Line Size: 4 bytes
            Interrupt: pin B routed to IRQ 16
            Region 0: Memory at dfdc0000 (64-bit, non-prefetchable) [size=64K]
            Expansion ROM at <ignored> [disabled]
            Capabilities: [40] PCI-X non-bridge device
                    Command: DPERE- ERO- RBC=2048 OST=1
                    Status: Dev=04:06.1 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz-
            Capabilities: [48] Power Management version 2
                    Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-)
                    Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
            Capabilities: [50] Vital Product Data
                    Product Name: Broadcom NetXtreme Gigabit Ethernet Controller
                    Read-only fields:
                            [PN] Part number: BCM95704A6
                            [EC] Engineering changes: 106679-15
                            [SN] Serial number: 0123456789
                            [MN] Manufacture ID: 31 34 65 34
                            [RV] Reserved: checksum bad, 26 byte(s) reserved
                    Read/write fields:
                            [YA] Asset tag: XYZ01234567
                            [RW] Read-write area: 107 byte(s) free
                    End
            Capabilities: [58] MSI: Enable- Count=1/8 Maskable- 64bit+
                    Address: fa7fb52dac9a6bfc  Data: a20a
            Kernel driver in use: tg3
            Kernel modules: tg3
    Last edited by CyberAngel; August 16th, 2013 at 01:43 PM. Reason: Marking SOLVED

  2. #2
    Join Date
    Nov 2005
    Location
    Athens,Greece-Oslo,Norway
    Beans
    358
    Distro
    Kubuntu

    Re: Silicom PXG4U Cannot Recognise all 4 Ethernet ports

    The card was defective! Changed and now everything works.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •